Brookstone Pocket Projector for iPhone 4 Device User Manual

Pocket Projector for
iPhone 4 Device
®
Video to go—projects up
to 50" images
Warnings
this product contains
a rechargeaBle BatterY
• Do not store this product
in high temperatures, damp
areas or in direct sunlight.
• Never disassemble the product.
• Never dispose of the product
in fire or water, which may result
in explosion and/or injury.
• Keep product out of reach
of children.
• Do not touch product with
damp hands.
• Dispose of the product properly.
• The product must not be
discarded with ordinary
household waste.
• Contact your local recycling
center for proper disposal.

save these instructiOns

LOcatiOn Of parts
and cOntrOLs
1. 30-Pin Connector
2. Volume Toggle Switch
3. Fine-tuning Focus Wheel
4. Lens
5. USB Port
6. LED Indicator Light
7. Power Switch
1
2
4 3
7 5
6
OperatiOn
charging projector
1. Connect the included USB cable
to both the Projector and a 2.0
USB port on your computer.
note: You may also charge the
projector with a usB/ac adapter
(not included).
2. The LED Indicator Light will
illuminate red to indicate the
Projector is currently charging and
then revert to green when
the Projector is fully charged.
important: Fully charge the projector's
internal battery before first use
(approximately 3 to 5 hours).
3. The LED Indicator Light will rapidly
flash blue when the Projector' s
battery is low. Connect the included
USB cable to recharge the
Projector' s battery.
docking
1. Slide your device straight down
onto the 30-pin Connector.
2. Power on the projector by pushing
the Power Switch to the right and
hold until the LED Indicator Light
illuminates blue. A blue light will also
illuminate from the projector' s lens.
3. You may now choose the video
you would like to view from the
menu on your device and play
it as you normally would.
Video Viewing
The Projector can display video
just about anywhere! For best video
quality, we suggest you find a light
colored wall (preferably white) and
place the Projector with its lens
facing the location.
Volume
Ensure the volume on your iPhone
4 device is set at its highest setting.
Then adjust the volume of your video
by pressing on the + or – of the
Volume Toggle Switch.
Focus
Roll the Focus Wheel to fine-tune
the picture.
charging Your iphone 4 deVice
with the projector
the projector also works as a back-up
battery for your iphone 4 device.
1. Dock your iPhone 4 device on
the fully-charged projector.
2. Slide the Power Switch to the left.
3. The projector's LED Indicator
Light will illuminate red while your
iPhone 4 device is charging.