Related Manuals for Frigidaire 220211A243
Summary of Contents for Frigidaire 220211A243
-
Page 1: Electronic Control
USE & CARE MANUAL READ AND SAVE THESE INSTRUCTIONS ELECTRONIC CONTROL AIR CONDITIONER P/N 220211A243... -
Page 2: Warranty
Your product is protected by this warranty Your appliance is warranted by Electrolux. Electrolux has authorized Frigidaire Consumer Services and their authorized servicers to perform service under this warranty. Electrolux authorizes no one else to change or add to any of these obligations under this warranty. Any obligations for service and parts under this warranty must be performed by Frigidaire Consumer Services or an authorized Frigidaire servicer. -
Page 3: Table Of Contents
Model No. Serial No. Register Your Product The self-addressed PRODUCT REGISTRATION CARD should be filled in completely, signed and returned to the Frigidaire Company. Warranty Product Registration Normal Sounds Important Safety Instructions... -
Page 4: Important Safety Instructions
• If the air conditioner is to be installed in a window, you will probably want to clean both sides of the glass first. If the window is a triple-track type with a screen panel included, remove the screen completely before installation. -
Page 5: Air Conditioner Features
Air Conditioner Features SET TEMP. FAN SPEED SET FAN TURNS UNIT SPEEDS ON OR OFF SETS MODES ACTIVATE TIMERS ENERGY SAVER ADJUSTS MODE TEMP & TIMES Fig. “A” REMOTE CONTROL SET TEMP. FAN SPEED SETS MODES ENERGY SAVER MODE ACTIVATE... - Page 6 Air Conditioner Features (continued) TO CHANGE TEMPERATURE SETTING: DO THIS: PRESS TO RAISE PRESS TO LOWER TO ADJUST FAN SPEEDS: DO THIS: PRESS FAN BUTTON SELECT SPEED TO USE AUTO TEMP FEATURE: DO THIS: PRESS FAN BUTTON SELECT AUTO TEMP...
- Page 7 Air Conditioner Features (continued) TO USE DRY MODE: DO THIS: PRESS MODE BUTTON CHOOSE DRY TO USE AUTO COOL: DO THIS: PRESS MODE BUTTON CHOOSE AUTO COOL TO OPERATE ON FAN ONLY: DO THIS: PRESS MODE BUTTON CHOOSE FAN YOU WILL SEE:...
- Page 8 Air Conditioner Features (continued) TO USE THE ENERGY SAVER FEATURE: DO THIS: PRESS ENERGY SAVER BUTTON TIMER: DELAY STOP / START FEATURE DO THIS: PRESS TIMER BUTTON THEN DO THIS: PRESS TEMP/TIMER BUTTON SLEEP FEATURE: DO THIS: PRESS SLEEP BUTTON...
- Page 9 Air Conditioner Features (continued) CHECK FILTER FEATURE: LIGHT On CLEAN AIR FEATURE (on some models): DO THIS: PRESS CLEAN AIR BUTTON REMOTE SENSING/FOLLOW ME FEATURE (on some models) SET TEMP. FAN SPEED DO THIS: PRESS REMOTE SENSING/FOLLOW ME BUTTON ON Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.
- Page 10 Air Conditioner Features (continued) FAULT CODES: If the display reads “AS” or “ED”, a sensor has failed. Contact your Authorized Frigidaire Service Center. TO TURN UNIT OFF: DO THIS: PRESS ON/ OFF BUTTON WARNING CODES: In the fan mode if “LO” or “HI” is displayed,...
- Page 11 Open (see Fig. 3) Figure 3 (VENT & EXHAUST) Air Directional Louvers Air directional louvers control air flow direction. Your air conditioner has the louver type described below. Auger Type The louvers will allow you to direct the air flow Up or Down and Left or Right throughout the room as needed.
-
Page 12: Care And Cleaning
• The capacity of the room air conditioner must fit the room size for efficient and satisfactory operation. • Install the room air conditioner on the shady side of your home. A window that faces north is best because it is shaded most of the day. -
Page 13: Avoid Service Checklist
Window vibration - poor installation. Refer to installation instructions or check with installer. Water dripping INSIDE when unit is Improper installation. Tilt air conditioner slightly to the outside to allow water drainage. Refer to installation cooling. instructions - check with installer.