Advertisement
Please be sure that your data module is downloaded with the
latest software and two-way protocol.
Never operate the C|3 when driving the vehicle.
Never leave small children or pets in an unattended vehicle.
Always install and test the remote starter or alarm system 100%
before proceeding to install the C|3. All operations must work
according to the manuals of these devices before C|3 is
installed.
Main Unit:
Mounting:
Mount the main C|3 unit in the interior of the vehicle. This may be
installed under the dash board or seating. Please insure that the unit is
close to the Alarm or remote start system so the data cables can be
connected. The unit can be mounted vertically or horizontally and must
be securely held to minimize vibration and movement that may impair the
driver's ability to operate the vehicle. Always solder all connections and
provide room to run the data, power and antenna cables.
Wiring:
Power connection:
Note: The power connection should be connected to the
proper power sources but not plugged in until the entire
installation has been complete. If the SIM card has not been
activated before power is applied to the unit, the unit will
need to be power-cycled after the SIM card is authorized by
unplugging the power and data connections for 5 seconds
and then plugging them back in.
Advertisement
