Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Audioplex Manuals
  4. Controller
  5. AUDIOFLEXNET SW2
  6. Installation manual

Audioplex AUDIOFLEXNET SW2 Installation Manual

Ip-based zone controller
Hide thumbs
1
2
3

Advertisement

Quick Links

Download this manual
AUDIOFLEXNET SW2 IP-BASED ZONE CONTROLLER
Connectors:
Dimensions:
Power Supply:
Your AUDIOFLEXNET SW-2 is designed to work as an IP-based zone controller and can be controlled by desktop
computer, laptop, tablet or and broswer enabled cell phone. Keep in mind that this unit does not offer impedance protection.
You are highly advised to use our Optimatch(tm) volume controls or another means of impedance matching such as Match-
It's(tm).
Wiring should be completed by following the wiring diagram on the back of this sheet. Wires should all be stripped
about 1/4", and tightly twisted to eliminate any chance of short circuits caused by stray wires. Snug but do not overtighten the
screw terminal. Also make sure that the correct wire is in the proper terminals (note that the INPUT connector block is green
and the OUTPUT connector blocks are black).
Consideration should be given to the weight of the wires attached to the unit. Supporting the wires will prevent the
switcher from falling backwards. The switcher can also be stacked under another heavier unit for support. This should be
done with care.
Once wiring is complete, go to page 3 of this manual for information on configuring your network.
Your AUDIOPLEX TECHNOLOGY AUDIOFLEXNET SW-2 is covered by a LIFETIME warranty against any
defects in workmanship and materials. Any defects will be remedied without charge for labor or parts.
Damage incurred by shipping or accident is not considered to be a defect, and not covered by this warranty. AUDIOPLEX
TECHNOLOGY , is not responsible for defective operation caused by abuse or by modification or service by any
unauthorized person or agency.
The unit must be properly installed and operated according to instructions for the warranty to apply. Any necessary
servicing must be done by AUDIOPLEX TECHNOLOGY. The product must be returned expenses prepaid, with written
authorization from the company. The product must be shipped with the proof of purchase and in the original carton and
packing material to avoid damage.
This warranty gives you specific legal rights. You may have other rights which vary from state to state.
INSTALLATION MANUAL
TECHNOLOGY

SPECIFICATIONS

Screw-type connectors capable of connecting 12 gauge wire
RJ-45 connector with connect and data activity indicators
14.375" W x 2.0"H x 6"D.
12 VDC 500ma (included)
INSTALLATION
WARRANTY
PAT APPLIED FOR
2008 - 7/10/2008

Advertisement

loading

Related Manuals for Audioplex AUDIOFLEXNET SW2

Summary of Contents for Audioplex AUDIOFLEXNET SW2

  • Page 1: Specifications

    Any defects will be remedied without charge for labor or parts. Damage incurred by shipping or accident is not considered to be a defect, and not covered by this warranty. AUDIOPLEX TECHNOLOGY , is not responsible for defective operation caused by abuse or by modification or service by any unauthorized person or agency.
  • Page 2 STEREO RECEIVER WIRING DOLBY DIGITAL OUT TO DIAGRAM NETWORK L+ L- R- R+ Note: INPUT connector block is green OUTPUT connector blocks are black INPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT ETHERNET L+ L- R- R+ L+ L- R- R+ L+ L- R- R+ L+ L- R- R+ L+ L- R- R+ L+ L- R- R+...
  • Page 3 CONFIGURATION Warning: Each AudioFlex device should be installed on the network one at a time. Install the first device and note it’s physical location in the building. Assign it a name by using the configuration web page on the AudioFlex device (config.htm).