External Power Source; Dvc Installation - ATN ThOR Series Operator's Manual

2.2.3. ExTERNAL POwER SOURCE

wARNING
when the unit is to be powered with external sources, first make
sure the batteries have been taken out.
as an external power source, a standard ac controller with outer
voltage of 12v and current of over 2a can be applied. To connect an
external source recommend to use a 6 mm standard double-pole
socket in the way the positive contact is the central contact.
Use the rca video/power adapter to connect an external 12v Dc/
2a power supply to the Thor.
connect an external power supply to the scope as follows:
1. remove the batteries.
2. remove the protective cap from the scope output connector
socket.
3. attach the rca video/power adapter to the output connector
socket.
4. Attach the power jack socket of the cable to a 12 V DC/ 2 A
power supply.
NOTES
1. The external power supply plug must have a 6 mm OD con-
tact with center pin positive.
2. Avoid a sudden removal of power source: use the power
button ON/OFF to turn the scope off before you remove bat-
teries or disconnect external power supply.
3. Replace the protective cap on the scope output connector
socket after disconnecting the cable.

2.2.4. DVC INSTALLATION

wARNING!
You are strongly recommended to mount the camera onto the
scope and to adjust it after the scope is adjusted or the weapon
is zeroed to fire with the scope pre-installed on it.
Dvc camera with Qrm preinstalled can be mounted onto the picat-
inny rail of the Thor.
2-6