Using Dlgdiag For Dos - Western Digital Data Lifeguard Diagnostic Utility User Manual

Using DLGDIAG for DOS

CAUTION: Back up all data on your hard drive(s) before using DLGDIAG. This
utility may write to the drive. As with all utilities that write to a drive, it is
recommended that you back up your data before proceeding.
1. Boot your computer to the DLGDIAG for DOS CD or floppy disk (see "Creating
Bootable DLGDIAG for DOS Disks" on page 10.
2. The DLGDIAG license agreement displays. Use the down arrow key to read through the
entire licence. Press Esc.
3. Press Y to start the program.
4. The DLGDIAG main menu displays. Use the up/down arrow keys to navigate the
options and the Enter key to select an option.
Select Drive
The Select Drive option shows a list of all drives installed and the current status of each drive.
1. For each drive that shows a status of 'DRIVE NOT TESTED', select the drive by using
the up/down arrows until the desired drive is highlighted and press Enter.
2. Press Esc to return to the main menu and test the drive.
DATA LIFEGUARD DIAGNOSTICS (DLGDIAG)
USER MANUAL
DLGDIAG FOR DOS – 11