Starting Cold Engine - Echo PB-760 LN H/T Operator's Manual

PB-760 LN H/T

Starting Cold Engine

• Recoil starter: Use short pulls - only 1/2-2/3 of rope length for starting. Do not allow the rope to snap back
in. Always hold the unit firmly.
• (PB-760 LN H): Rotate spring loaded throttle arm downward to a comfortable operating position.
- PB-760 LN H
1. Throttle Lever
Move throttle position lever (A) to IDLE DETENT positions.
- PB-760 LN T
1. Throttle Position / Stop Switch Button
Slide Throttle Position / Stop Switch Button (A) back to idle
position.
- PB-760 LN H and T
2. Choke
Move choke (C) up to Cold Start Position (
3. Purge Bulb
Pump purge bulb (D) until fuel is visible. Pump bulb an
additional 4 or 5 times.
4. Recoil Starter
Pull recoil starter handle (E) until engine fires, or a maximum
of 5 pulls
5. Choke
After engine fires (or 5 pulls), move choke lever back to Run (
until engine starts and runs. Allow unit to warm up at idle for several minutes.
Note: If engine does not start with choke in "Run" position after 5 pulls, move choke to "Cold Start" (
position, and repeat steps 4 & 5.
6. Throttle Lever
Allow engine to warm up for several minutes before use.
7. Throttle Lever
After engine warm-up, move throttle lever gradually to increase engine RPM to desired operating speed.
X7531125002
© 03/2013 ECHO Inc.
PB-760 LN H
PB-760 LN T
C
)
E
D
) position, then pull starter handle/rope
OPERATION
A
)
19