Dyson DC25 Operating Manual page 5

Hide thumbs Also See for DC25:
Table of Contents

Advertisement

ASSEMblY
Lie vacuum flat and attach cleaner head by sliding it on until it clicks.
Stand vacuum up straight, attach wand to hose and push into place until it clicks.
Push wand down into hose and attach tools to the side of the vacuum.
USINg YOUR dYSON vACUUM
Press foot pedal and recline handle to use. The stabilizer stand will automatically
lift up. To switch 'ON', depress power button in front of handle. After cleaning,
push vacuum into an upright position and stabilizer wheels will automatically
drop. Use the cyclone carry handle to carry the vacuum.
CAUTION:
Do not use or store this machine below 32°F (0°C). Ensure that the machine is at
room temperature before operating.
Do not allow the vacuum to be used by anyone who may not be able to
operate it safely.
The use of an extension cord is not recommended.
Always switch off and unplug the vacuum before performing maintenance on
your vacuum.
When returning to the upright position, ensure that the stabilizer wheels are fully
engaged before releasing the vacuum.
Ensure the cyclone is secured to the vacuum. Do not press the cyclone release
button or shake the vacuum while carrying or it could fall and cause injury.
Store the vacuum indoors. Put the vacuum away after use with the cord coiled
safely, to prevent tripping hazards.
Do not use outdoors or on wet surfaces or to vacuum water or other liquids –
electric shock could occur.
Check to ensure your electricity supply corresponds to that shown on the rating
plate, which can be found behind the clear bin™. The vacuum must only be used
as rated.
Do not lubricate any parts, or carry out any maintenance or repair work
other than that shown in this Dyson Operating Manual, or advised by the
Dyson Helpline.
PLEASE NOTE:
This vacuum is intended for domestic use only. Fine dust such as plaster dust or
flour should only be vacuumed in very small amounts.
Do not use the vacuum to pick up sharp hard objects, small toys, pins, paper
clips, etc. They may damage the vacuum.
Consult your flooring manufacturer's recommended instructions before
vacuuming and caring for your flooring, rugs, and carpet. The brush bar on the
machine can damage certain carpet types and floors.
If unsure turn brush bar off in order to enable proper operation. Some carpets
will fuzz if a rotating brush bar is used when vacuuming. If this happens, we
recommend vacuuming in bare floors mode and consulting with your flooring
manufacturer.
When vacuuming, certain carpets may generate small static charges in the
clear bin
or wand. These are entirely harmless and are not associated with
TM
the electricity supply. To minimize any effect from this, do not put your hand or
insert any object into the clear bin
unless you have first emptied it and rinsed it
TM
out with cold water (see 'clear bin
cleaning section).
TM
CARPETS/hARd FlOORS
The brush bar will always default to 'ON' (spinning) each time you switch on
the vacuum and recline it for cleaning. The brush bar will automatically stop
if it becomes obstructed. If the brush bar stops during use, please refer to the
'Clearing brush bar obstructions' section.
To switch the brush bar off (e.g. for hard floors), recline the vacuum and
turn it 'ON', then press the brush bar 'ON/OFF' button – the brush bar
will stop spinning.
hIgh-REACh ClEANINg
CAUTION:
Switch 'OFF' vacuum before changing tools.
Powerful suction can cause the hose to 'pull back' - please take care.
Take extra care when vacuuming on stairs; do not work with the vacuum above
you on the stairs. Do not put the vacuum on chairs, tables etc.
Ensure vacuum is in upright position before using tools.
PLEASE NOTE:
To release the wand, open the wand cap and pull the red tube until the wand
releases from the vacuum. Tools can be attached to either the hose or wand.
The brush bar will not rotate when the vacuum is in an upright position.
Ensure wand cap is closed when not in use.
ClEAR bIN
EMPTYINg
TM
CAUTION:
PLEASE NOTE:
Switch 'OFF' vacuum and unplug the vacuum before emptying the clear bin™
Empty as soon as the dirt reaches the level of the MAX mark – do not overfill.
To remove the clear bin™ from the vacuum press the button at rear of cyclone
carrying handle. To release the dirt, press the red clear bin™ release button.
Do not use the vacuum without the clear bin™ in place.
To minimise dust/allergen contact when emptying, encase bin tightly in a plastic
bag and empty. Remove bin carefully and seal bag tightly, dispose as normal.
8
ClEAR bIN
ClEANINg
TM
CAUTION:
Do not immerse the whole cyclone in water or pour water into the cyclones.
Ensure the clear bin
is completely dry before replacing.
TM
PLEASE NOTE:
Do not use detergents, polishes or air fresheners to clean the clear bin
Clean the shroud with a cloth or dry brush to remove lint and dust.
Do not put clear bin
in a dishwasher.
TM
WAShINg YOUR FIlTERS
dO ThIS EvERY 3 MONThS
CAUTION:
Switch 'OFF' and unplug the vacuum before removing the filters.
Ensure filters are completely dry before refitting to the vacuum.
PLEASE NOTE:
This vacuum has two filters, located as shown. It is important to check your
filters regularly and wash at least every 3 months according to instructions, to
maintain performance.
The filter in the ball should be rinsed and tapped out until the water runs clean,
then tapped out again to ensure all excess water is removed. Please leave to dry
completely for 24 hours.
It is normal for this filter in the ball to turn grey in color. The filters may require
more frequent washing if vacuuming fine dust.
Do not use detergents to clean the filters.
Do not put the filters in a dishwasher, washing machine, tumble dryer, oven,
microwave or near an open flame.
lOOKINg FOR blOCKAgES
CAUTION:
Switch 'OFF' and unplug the vacuum before checking for blockages. Failure to
do so could result in personal injury.
Please ensure the vacuum is upright and switched off before removing hose or
airway inspection parts.
Beware of sharp objects when clearing blockages.
Refit all parts of the vacuum securely before using.
PLEASE NOTE:
Clearing blockages is not covered by your vacuum's limited warranty.
This vacuum is fitted with a thermal cut-out. If any part of your vacuum becomes
blocked, it may overheat and then automatically shut off. Switch 'OFF' and
unplug the vacuum and leave to cool down for at least 60 minutes before
attempting to check filters or for blockages. Clear blockage before restarting.
ClEARINg bRUSh bAR ObSTRUCTIONS
CAUTION:
Switch off and unplug the vacuum before clearing brush bar obstructions.
Failure to do so could result in personal injury.
If your brush bar is obstructed, it may shut off. If this happens you will need to
remove the brush bar as shown and clear any obstructing debris. Refit all parts
securely before use.
Beware of sharp objects when clearing obstructions.
Refit all parts of the vacuum securely before using.
PLEASE NOTE:
Cleaning the brush bar obstructions is not covered by your vacuum's limited
warranty.
dYSON CUSTOMER CARE
THANK YOU FOR CHOOSING TO BUY A DYSON VACUUM
If you have a question about your Dyson vacuum, call the Dyson Helpline at
1-866-693-9766 with your serial number and details of where and when you
bought the vacuum. Your serial number can be found on the rating plate, which
is behind the clear bin
. Most questions can be solved over the phone by one of
TM
.
TM
our Dyson Helpline staff. If your vacuum needs service, call the Dyson Helpline so
we can discuss the available options. If your vacuum is under warranty, and it is a
covered repair, it will be repaired at no cost.
dYSON hElPlINE
Call 1-866-693-9766 toll free, 7 days a week.
PlEASE REgISTER AS A dYSON vACUUM OWNER
To help us ensure you receive prompt and efficient service, please register as a
Dyson vacuum owner. There are three ways to do this:
Online at www.dyson.com
By calling the Dyson Helpline: 1-866-693-9766.
By completing and returning the attached Warranty Form to us by mail.
This will confirm ownership of your Dyson vacuum in the event of an insurance loss,
and enable us to contact you if necessary.
5 YEAR WARRANTY
Terms and conditions of the Dyson 5 year limited warranty.
WhAT IS COvEREd
Your Dyson vacuum is warranted against original defects in material and
workmanship for a period of five years from the date of purchase, when used
for private household purposes in accordance with the operating manual. This
warranty provides, at no extra cost to you, all labor and parts necessary to ensure
your vacuum is in proper operating condition during the warranty period. This
limited warranty is subject to the following terms:
WhAT IS NOT COvEREd
Dyson, Inc. shall not be liable for costs, damages or repairs incurred
as a result of:
Vacuums purchased from an unauthorized dealer.
Clearing blockages from your vacuum.
Use of parts not in accordance with the Dyson Operating Manual.
Careless operation or handling, misuse, abuse and/or lack of maintenance
or use not in accordance with the Dyson Operating Manual.
External sources such as weather.
Repairs or alterations carried out by unauthorized parties or agents.
Use of the vacuum other than for normal domestic purposes within the United
States, e.g. for commercial or rental purposes.
Normal wear and tear, including normal wearing parts, such as clear bin
filter, brush bar, hose assembly and power cord (or where external damage or
abuse is diagnosed), carpet or floor damage due to use not in accordance with
manufacturers instructions or failure to turn the brush bar off when neccessary.
Use of parts and accessories other than those produced or recommended
by Dyson, Inc.
WARRANTY SERvICE
Please fill out and return the Warranty Form, or register online at www.dyson.com
Before service can take place, the terms of the limited warranty require that you
contact the Dyson Helpline with your model name/number, serial number, date
and place of purchase. Please keep your purchase receipt in a safe place to ensure
you have this information. The serial number is found on the vacuum's rating plate,
which is behind the clear bin
.
TM
All work will be carried out by Dyson, Inc. or its authorized agents.
Any replaced defective parts will become the property of Dyson, Inc.
Service under this warranty will not extend the period of this warranty.
If your vacuum is not functioning properly, please call the Dyson Helpline at 1-866-
693-9766. Most issues can be rectified over the telephone by our trained Customer
Care staff. If this is not possible Dyson, Inc. will arrange for your vacuum to be
repaired and returned in full working order at no extra cost to yourself.
WARRANTY lIMITATIONS ANd ExClUSIONS
Any implied warranties relating to your vacuum, including but not limited to
warranty of merchantability or warranty of fitness for a particular purpose, are
limited to the duration of this warranty. This limitation is not allowed by some
States and so this limitation may not apply to you.
Your remedy for breach of this warranty is limited to the warranty service described
above. Dyson, Inc. will not be liable for any consequential damages or incidental
damages you may incur in connection with your purchase and use of your vacuum.
This limitation is not allowed by some States and so this limitation may not apply
to you.
This limited warranty gives you specific legal rights. You may also have other rights
which vary by State.
This limited warranty is not transferable.
IMPORTANT dATA PROTECTION INFORMATION
Your details will be held by Dyson, Inc. or others on behalf of Dyson, Inc. so that
we can assist you more quickly in our Customer Service department. From time to
time, Dyson, Inc. may send you special offers and news of our latest innovations.
Check the box on the Warranty Form within the Operating Manual if you do not
wish to receive marketing or promotional information from Dyson, Inc. For more
information about our data collection practices, please refer to the Dyson, Inc.
privacy policy at www.dyson.com/privacy
TM
, belt,
PROdUCT INFORMATION:
Net weight: 16.12lbs (7.30kg).
Please note: Small details may vary from those shown.
This product is protected by the following intellectual property rights:
PATENT/PATENT APPlICATION NUMbERS:
JP 2004-537336; EP 1361812; AU 744408; EP 1119282; JP 2002-527132;
US 6,519,807; AU 744362; EP 1121043; JP 2002-527131; US 6,572,078;
GB 0326102.1; AU 2002-226556; EP 1370172; JP 2004-528876;
US 6,991,666; AU 2002-225207; EP 1361814; JP 2004-520137; US 7,018,439;
AU 2001-240894; EP 1268076; JP 2003-528704; US 6,835,222;
AU 2002-225232; EP 1361815; JP 3940082; US 6,974,488; AU 2003-283157;
EP 1526796; JP 2006-503607; US 2005-0235454; AU 2003-283159;
EP 1526797; JP 2005-534442; AU 2003-283161; EP 1526798;
JP 2006-503608; AU 2004-294771; EP 1680232; JP 2007-508934;
US 2007-0079579; AU 2005-263889; EP 1768536.
Equivalent patents, registered designs and applications exist in other countries.
9

Advertisement

Table of Contents
loading

Table of Contents