Table of Contents
Advertisement
POURING
The kettle features a oversized non-drip smooth flow spout.
•
Remove the kettle from the power base before pouring
•
When filling or carrying the kettle, do not tilt it
backwards, as this may allow water to pass through the
steam tube onto the control area. Should this happen,
the kettle must be allowed to dry before re-using
•
To avoid the risk of splashing, once the kettle has
boiled wait 10 seconds then pour slowly. Do not
over-tilt the kettle.
WARNING: IF THE KETTLE HAS JUST BOILED,
IT WILL BE FULL OF STEAM, WHICH WILL
ESCAPE AS SOON AS THE LID IS OPENED.
BOIL-DRY
If the kettle is accidentally switched on with no water inside, the boil-dry
device will switch off the heating element to prevent damage to the kettle.
•
Do not switch the kettle on unless it contains at least
one cup of water. Misuse of this kind will shorten the
life of the kettle
•
If the kettle is accidentally switched on when it does not
contain sufficient water, a boil-dry device will
automatically switch it off
•
Wait until the kettle has cooled down before refilling.
The lid may be hot and the water may spit as it
touches the kettle base.
10
CARE & CLEANING
Regular cleaning & care will keep your kettle looking newer for longer and
help prolong the life of the kettle.
•
Switch the kettle off, lift it from the power base, unplug
the power base from the wall socket and L L E E T T T T H H E E
K K E E T T T T L L E E C C O O O O L L D D O O W W N N C C O O M M P P L L E E T T E E L L Y Y B B E E F F O O R R E E
C C L L E E A A N N I I N N G G . . Wipe the outside and inside surfaces of
the kettle with a damp cloth
•
If necessary, you may use a mild household detergent.
To clean the filter, see 'water filter' section below
•
If you use detergent inside the kettle, rinse thoroughly
afterwards to remove all traces
•
Ensure that all connectors and sockets are kept dry
•
Do not immerse the kettle or power base in water or
any other liquid
•
Do not use harsh or abrasive cleaners or solvents.
WATER FILTER
DO NOT OPERATE THE KETTLE UNLESS THE WATER FILTER IS
CORRECTLY IN POSITION.
•
Make sure hands are clean and free from hand cream,
soap or similar, which might leave a slight taint to the
water
•
Remove the kettle from the power base and ensure
kettle is cold
•
Open the lid. Hold the top of the filter and push
gently down then pull towards the handle and lift up
and out of the kettle. Rinse under a tap while
carefully brushing it with a soft brush. Rinse the kettle
out with fresh water
•
To replace, align the clips of the filter with the grooves
in the kettle, and insert and push back into place.
PUSH THEN
PULL OUT
11
Advertisement
Table of Contents
