Finding New Stations; Maximising Signal Strength - Dualit DAB LITE RADIO Instructions And Guarantee

FINDING NEW STATIONS

New stations may become available over time. You can
manually start an Autotune Scan by pressing the
SCAN button.
This will conduct a search of radio frequency signals and
automatically add any new stations to the memory. You
will see any new stations on the list when you rotate the
TUNE knob to select a station.
To perform a scan of UK radio frequencies, press the
• •
SCAN button and the display will show 'Fast
Scanning'. Your radio will perform the same scan of
Band III DAB frequencies that it did when you first
switched it on. It will take about 20 seconds.
If using the radio outside the UK, you will need
• •
to perform a full scan of all Band III
frequencies. Press and hold the SCAN button
for three seconds, the display will show
'Full Scanning'. This will take about one
minute.
DAB MODE

MAXIMISING SIGNAL STRENGTH

DAB signal strength can vary greatly in different locations.
Use the signal strength indicator, to help position the radio
in the best position location.
Press and release the TUNE knob until the display
• •
shows the signal strength indicator.
Move the radio around and carefully angle the
• •
telescopic aerial to maximise reception, using the
signal strength bar display as a guide.
POOR
SIGNAL
VS.
GOOD
SIGNAL
The clear unfilled rectangle indicates minimum signal
• •
level required for satisfactory reception; the higher the
number of solid rectangles the stronger the signal.
15