Dualit FOOD PROCESSOR Instruction Manual page 17

ONLY HANDLE DISCS BY THE PLASTIC
CENTRE SECTION.
The shaving and shredding discs can be used with all
bowls. The chipping disc can be used with the large and
medium bowls only. They always need to be attached to
the bowl drive via the drive shaft. Add your Ingredients
via the feeder tube after the lid is locked in position.
• Discs must be inserted with the cutting face
upwards (the chip is a single sided disc check it is
the correct way up). Attach the disc directly onto the
drive shaft, gently push down and twist until
securely in position
• Align and lock the lid into position
• Pack the ingredients into the feeder tube
• When using the processor with these discs, push the
ingredients down the feeder tube using the food
pusher.
HANDLE WITH CARE WHEN ADJUSTING,
THE BLADE IS EXTREMELY SHARP
The adjustable slicing disc can only be used with the
large and medium bowls. It creates any slice thickness
between 0.5mm and 7.5mm. It must be attached to the
drive shaft.
• To adjust the slicing thickness, rotate the outer
spindle on the underside of the disc anti-clockwise to
make the slices thicker, or clockwise to make them
thinner
• The adjustable slicing disc is then attached to the
drive shaft with the cutting edge uppermost
• The lid is locked on, the ingredients gently packed
into the feeder tube and the food pusher used to
push the ingredients through the cutter.
ASSEMBLING AND USING YOUR PROCESSOR
GRATING & SHAVING, SHREDDING AND CHIPPING DISCS
ADJUSTABLE SLICING DISC
17