DSC PC2525 Instruction Manual page 7

PC2550RK KEYPAD
1 5
2 6
3 7
4 8
ZONE BYPASSING: Press [ ] then [1], then
press the zone you wish to bypass.
[#] to return to "Ready". Arm System.
PROGRAMMING USER CODES: Press [ ] then
[5], [Master Code] then press 1 thru 8 for
the user code you wish to program.
enter a four digit code, press [#] to return to
ready.
INSTANT ARM: Press [ ][9] before any user
code to arm system without entry delay.
ARM INTERIOR Press
QUICK EXIT Press
QUICK ARM Press
F A
NOT NOT
IN IN
USE USE
TEST SYSTEM WEEKLY
PC255ORK
18000120 R2
[F] Key: Press and hold this key for 2 seconds to sound a Fire alarm
[A] Key: Press and hold this key for 2 seconds to generate an Auxiliary alarm
[P] Key: Press and hold this key for 2 seconds to generate a Panic alarm.
These keys will not function unless enabled by your Installer.
The "Fire" light will come ON where there is any Fire
Alarm condition.
The "Ready" light will come ON when the system is
ready to be armed. When the "Ready" light is OFF,
there is an open zone on the system. The zone must
be closed or bypassed before the system can be
armed.
The "Armed" light will come ON to indicate that the
system is armed. The "Armed" light will FLASH to
indicate that the system is armed and that there is no
Entry Delay on any of the zones.
The "Memory" light will come ON where there are
alarms in memory. Enter [ ][3] to view the zones that
went into alarm while the system was armed. Press [#]
to return to "Ready".
Important:
Follow the instructions in the manual to test your system weekly. Follow the
guidelines for correcting system trouble conditions; have any system trouble
conditions you cannot correct yourself attended to by your installer.
Press
Then
P
NOT
F A
IN
USE
5
6
1
2 7
3 8
4
P
The "Bypass" light will come ON when there are
bypassed zones. Enter [ ][1] to view the zones that
are bypassed. Ensure that any bypassed zones are
bypassed intentionally before arming the system.
Press [#] to return to "Ready".
The "Trouble" light will come ON where there is a
trouble condition present on the system. Enter [ ][2]
to view trouble conditions.
"Ready".
The "Program" light will come ON when Access
Codes are being programmed and when system
functions are being changed.
Press [#]:
• when an error is made in entering an Access Code,
then enter the code again
• to return to "Ready" after using [ ] commands
Zone Lights 1 to 8
indicate zone activity.
With the system
disarmed, the Zone
Lights will come ON to
indicate when zones are
active, and the Zone
Lights will be shut OFF
to indicate that zones
are secure.
Press [#] to return to
5