Download Print this page

DLS ULTIMATE UP5 Owner's Manual page 3

Ultimate series car audio speakers

Advertisement

Filter installation and connection of UR5i & UR6i
Filter installation and connection of UR35i & UR36i 3-way systems
Coil
Car stereo / amp.
FACTS DLS UP2.5 MID-DOME
Size
2,5" ( 6,3 cm)
Nom. power (RMS)
90 Watts RMS
Maximum power
160 Watts
Frequency range
400 Hz-8 kHz
Sensitivity
91 dB / W / m
Resonanst freq. / Fs
350 Hz
Magnet diameter
65 mm / 2,56"
Outer diameter
100 mm / 3,94"
Mount. depth
25 mm / 1"
Mount. hole
82 mm / 3,23"
Cone
Doped fabric
Voice coil
52 mm / 2" al flat wire
FILTER/CROSSOVER INSTALLATIONS
Tweeter
-
+
-
+
Bass/mid
Head unit / amp.
Jumper setting:
TWEETER LEVEL
Select tweeter level by moving the small jumper inside the filter
box.
High level
Mid level
Bass
+
Mid
+
+
Tweeter
+
FACTS DLS UR2.5 MID-DOME
Size
Nom. power (RMS)
Maximum power
Frequency range
Sensitivity
Resonanst freq. / Fs
Magnet diameter
Outer diameter
Mount. depth
Mount. hole
Cone
Voice coil
Low level
The drawing shows the connection of a 3-way system to one channel. The
other channel is connected in the same way. The tweeter and mid levels
are adjustable in two steps as described below:
Tweeter level (J3):
High = jumper mounted between pin 1-2.
Low = jumper mounted between pin 1-3.
Midrange level (J2):
High = jumper mounted between pin 1-2.
Low = jumper mounted between pin 1-3.
Jumper J1 is used when you want to run the system without
midbass driver. In this case some components inside the filter must
be disconnected.
Midbass connected: jumpers mounted between pin 1-2 & 3-4.
Midbass disconnected: jumpers mounted between pin 1-3 & 2-4.
2,5" ( 6,3 cm)
90 Watts RMS
160 Watts
400 Hz-8 kHz
91 dB / W / m
350 Hz
85 mm / 3,35"
100 mm / 3,94"
36 mm / 1,42"
82 mm / 3,23"
Doped fabric
52 mm / 2" al flat wire
UP2,5 / UR2,5
Should be installed high up in
the
door
side
or
in
dashboard.
Normally
these
speakers don´t require any
box. When the midrange is
mounted
high
up
in
dashboard
the
mid
level
becomes
high
in
some
vehicles. If so use the low mid
level in the filter box. If the level
is still too high, connect a 3-5
ohm resistor in series with the
+ feed.
the
the

Advertisement

loading

This manual is also suitable for:

Ultimate up6Ultimate up36Ultimate up35Ultimate ur5iUltimate ur6iUltimate ur35i ... Show all