Table of Contents
Advertisement
A. Installing the Strobe Light Using the Included Weatherproof Box
*** SL-2/SL-2-EWP
Blue Strobe Light
* Note: The gel-filled (water tight) butt connectors are designed for insulation displacement. Do not strip wires
prior to terminating.
** Important: First fully tighten the nipple into the faceplate. Next add the (2) nylon spacers, then fasten the strobe
mounting ring.
*** Note: For outdoor applications, orient the blue strobe light with the screws at the top and bottom. Use a bead
of silicone to fill any gaps or spaces to prevent water from entering the strobe light.
B. Front Mounting Without Weatherproof Box
The BLK-4 Strobe Light Kit may be
mounted without using the included
weatherproof box. To mount the
strobe light from the front, use the
diagram shown to the right.
C. Rear Mounting Without Weatherproof Box
To mount the strobe light from the rear,
use the diagram shown to the right.
(2) 10-32 x 3/8" self
tapping screws
(2) 7/8" Nylon
Foam
Strobe
Gasket
Mounting Ring
SL-2/SL-2-EWP
Strobe Light
(included)
Installation
(2) 6-32 x 3/4"
** Nipple
screws
1/2" x close
spacers
1/2" Close Nipple
Faceplate
(2) #8-32 x 2 1/2 Phillips
Head Self Tapping Screws (included)
(2) #10-32 x 5/8
Phillips Head Self
Tapping Screws
(included)
To BLK-4 Control
Module (included)
*
Gel-Filled Butt
Connectors (included)
Red
Red
Black
Black
Green
Green
Control
Module
Foam
Gasket
2.75"
RED
GREEN
BLACK
(2) Knockout
Plugs
Internal View of the
Weatherproof Single
Gang Box (included)
Wall, post, etc.
To BLK-4
RED
GREEN
Control
BLACK
Module
(included)
SL-2/SL-2-EWP
Strobe Light
(included)
3
Advertisement
Table of Contents
