Page 1
D00748600B FireWire Control Surface Expander OWNER’S MANUAL CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT Ü REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert ÿ...
Do not install this apparatus in a confined space the manufacturer. such as a book case or similar unit. The apparatus draws nominal non-operating power from the AC outlet with its POWER switch in the off position. TASCAM FE-8 Owner’s Manual...
Warnung Dies is eine Einrichtung, welche die Funk-Entstörung nach Klasse A besitzt. Diese Einrichtung kann im Wohnbereich Funkstörungen versursachen ; in die- sem Fall kann vom Betrieber verlang werden, ange- messene Maßnahmen durchzuführen und dafür aufzukommen. TASCAM FE-8 Owner’s Manual...
1 – Introduction and installation Thank you for purchasing the TASCAM FE-8 fader It is possible to add up to 15 FE-8 units to the FW- expansion unit. This is designed to be used with the 1884, making a total of 128 channels.
FW-1884 (the illustration below shows the left end cheek). WARNING The FE-8 is designed to be used with the FW-1884 only as described in the instructions here. Only use it in this way, as there is a danger of electric shock under other conditions (that is, when standing apart from the FW- Fix the end cheek to the side of the FE-8.
Page 7
FW- 1884. If you are adding more than one FE-8 unit to your NOTE FW-1884 setup, you should use the mounting pads to link the FE-8 units, and replace the end cheek(s) only You can use the FE-8 only in conjunction with an FW- on the units at the end(s) of the line.
Page 8
FE-8 in all versions of the software, as explained below. Naming the FE-8 units If you have more than one FE-8 unit in your system, tab in the Control Panel allows you to FE-8 it may be difficult for you to keep track of the differ- rename the units to something more meaningful.
15 A Applicable electromagnetic environment Dimensions (W xHxD) 260 x 133 x 478 (mm) 10.25 x 5.2 x 18.9 (in.) Weight 5 kg (11 lbs.) Supplied accessories IEEE 1394 cable, mounting pad (sheet joint), AC power cable 260mm (10.2") TASCAM FE-8...
Need help?
Do you have a question about the FE-8 and is the answer not in the manual?
Questions and answers