Tascam CD-GT1mkII Owner's Manual page 20

Using built-in effects (Continued)
(continued from the previous page)
and number (such as
represents a set of effect presets.
The effect presets appear in this
order: distortion d01 – 15, over-
drive o01 – 15, clean sound c01 –
15, Vocal v01 – 12. Select a library
preset effect by pressing either the
UP or DOWN key.
TIP
The Effect Preset Chart (See Effects presets)
shows the 57 effect presets in the library. The
45 guitar effect presets contain four compo-
nents, and you can mix the two shown in
bold. The 12 vocal effect presets contain only
one component. Use the chart to determine
the content of a selected library number.
CAUTION
If there are any settings in the selected bank
slot to start with, they will be overwritten
when you recall a library entry.
7. Use the PREV or NEXT
move between the components
of the effect preset. For example,
if you choose "clean sound 12,"
shown as , the components
LIB:c12
20
— TASCAM CD-GT1MKII
are:
COMP
components can be adjusted by
) that
LIB:d10
pressing either the
key. In the example of "clean
sound 12," each of the
components are followed in the
display by their own mix param-
eter, with
following
MIX 2
UP or
and
DLY
8. Continue to select the compo-
nents to edit by pressing either the
PREV
the value for the selected compo-
nents by pressing either the
DOWN
9. The last parameter of the sequence
for each library effect preset is
(the output level from the effect
LVL
unit). Set the output level from 0
to 64 by pressing either the
key to
DOWN
level is only available when the ef-
fect is turned on and is bypassed
when the effect is off.
, , , . All four
TONE VIB DLY
UP or DOWN
and
VIB DLY
following and
MIX 1 VIB
. Press either the
DLY
DOWN key to mix the
VIB
components in the effect.
or NEXT key, then select
or
UP
key.
UP or
key. Note that the output
10. Press the TIME/ESC
the effect settings. The effect set-
tings you have made are automati-
cally stored in the bank slot you
first chose in steps 1 and 2.
Recalling an effect with your
settings
When you have stored the effect set-
tings in a bank slot as described above,
you can recall them simply pressing
the BANK key and No./EDIT
select the appropriate bank slot. You
should also make sure that effect (
is switched ON.
TIP
If you have connected a footswitch such as
TASCAM RC-30P (sold separately), you can
step through the bank slots by pressing the
footswitch. Make sure that FOOT in the Setup
menu is set to either FX+, FX-, or BNK.
key to exit
key to
EFF)