Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Alliance Laundry Systems UL15F069
Summary of Contents for Alliance Laundry Systems UL15F069
- Page 1 Chest Heated Finishers 15 inch (370 mm) Models and 20 inch (500 mm) Models Refer to Page 2 for Model Identification Keep These Instructions for Future Reference. (If this machine changes ownership, this manual must accompany machine.) Part No. 1800001R1 www.comlaundry.com September 2007...
-
Page 3: Table Of Contents
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher. 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 4: Introduction
Information in this manual is applicable to these models: UL15F069 UL20F079 UL15F079 UL20F099 UL15F099 UL20F118 UL15F118 UL20F130 UL15R069 UL20R079 UL15R079 UL20R099 UL15R099 UL20R118 UL15R118 UL20R130 UL20A118 UL20A130 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 5: Serial Plate Location
Customer Service For technical assistance, call the following number: (920) 748-3121 Ripon, Wisconsin P101119 Serial Plate Figure 1 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 6: Safety
CAUTION Indicates a hazardous situation that, if not avoided, may cause minor or moderate personal injury or property damage. 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 7: Important Safety Instructions
State of California to cause cancer, birth defects, or other reproductive harm. 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... - Page 8 24. Do not crawl or walk on the machine. 25. Always wear protective gloves when working at the machine. The beds are hot and hot linen exits the machine. 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT...
-
Page 9: Installation
(1450 kg) (1600 kg) (1725 kg) (1850 kg) Approx. Net Weight 2645 lb. 2976 lb. 3252 lb. 3527 lb (1200 kg) (1350 kg) (1475 kg) (1600 kg) 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 10: Dimensions
118 in. (1750 mm) (2000 mm) (2500 mm) (3000 mm) 15 in. 15 in. 15 in. 15 in. (370 mm) (370 mm) (370 mm) (370 mm) Table 1 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 11: Dimensions
130 in. (2000 mm) (2500 mm) (3000 mm) (3300 mm) 20 in. 20 in. 20 in. 20 in. (500 mm) (500 mm) (500 mm) (500 mm) Table 2 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 12: Pre-Installation Inspection
Allow sufficient space in front so operator can ● technicians. work efficiently and safely. W678 FOR REAR RETURN MODELS Allow sufficient space in front and rear so ● operator can work efficiently and safely. 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 13: Moving Finisher With Crane
10. Level finisher. 5. Once finisher is in final position, open hydraulic valve to release chest. 6. Remove all packing materials. 7. Level finisher. 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 14: Electrical Connection
If all three are rotating properly proceed. If they are not, reverse polarity of component not rotating properly. 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 15: Gas Connection
IMPORTANT: For L.P. (Liquefied Petroleum) gas, correct the total BTU/hour by multiplying it by 0.6. The answer is the equivalent BTU on the above chart. Table 5 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 16: Inlet Pressure
(52 kW) Burner 40 cfm 40 cfm 40 cfm 61 cfm 40 cfm 61 cfm 64 cfm 67 cfm Exhaust Burner Exhaust Inches of Water Column Table 6 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 17: Exhaust Requirements
IMPORTANT: Do not obstruct flow of combustion and ventilation air. WARNING Do not connect vents together. Gas and ventilation outlets must be separate to prevent fire. Insulate all ducts to prevent fire. W680 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 18: Commissioning Procedures
4. Place one end of the teflon hose into a tub. Refer to Figure 6. 5. Let teflon hose drain into tub. 6. Remove the teflon hose. 7. Replace original hose. Drain into tub Figure 6 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 19: Operation Instructions
7. Check the condition of the feed bands. 8. Check for proper function of the emergency stop buttons. 9. Clean dust off machine. 10. Check the machine for leaks. 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 20: Operating Instructions
LED "OUT": Status light of the output. Blinks when again. Touching the finger guard will stop the roll in set point display/change mode or during programming. 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 21: Maintenance
1.2 liter (0.3 gallons) Gas Models 2.5 liter (0.7 gallons) 30 liter (8 gallons) Oil Volume Electric Models 90 liters (24 gallons) Table 8 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 22: Cleaning The Beds
2. Affix the felt with one screw at each end of the roll and bed. That may cause spots in the ironed roller. Do not trim off the sides yet. items because padding absorbs wax. 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 23: Baking Of Roll Padding
8. Make holes in the felt and screw the felt down around the rollers at both ends using screws retained from the old clothing. 9. Tension the clothing. 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 24: Hydraulic Pressure Settings
1. Remove cap from side of hydraulic pump. Refer to Figure 7. 3. Reinstall cap. Baking Starting After 10 Days Table 9 FWF98N FWF98N Figure 7 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 25: Scrapers
3. Grease the beds with some oil to prevent rusting by feeding an oil cloth. 4. Keep carrying out the annual maintenance (oil change, greasing, etc.). 5. Before starting the ironer again, clean the beds. 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 26: Troubleshooting
1. Gas pressure is too high. 1. Adjust gas pressure on 13 mbar (0.2 2. Gas valve is badly adjusted. psi). 2. Adjust gas valve. Contact technical service for instruction. 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 27: Troubleshooting Undesirable Finishes
NOTE: The entire width of the finisher should be used to prevent overheating the unused surface. Small articles should be processed in a pattern that utilizes the entire width. 1800001 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT...
Need help?
Do you have a question about the UL15F069 and is the answer not in the manual?
Questions and answers