M
AKING
This chapter discusses how to connect end nodes, and
uplink two hubs together.
Connecting to computers
After the hub is properly installed, it can support up to
five/eight computers.
1. Insert one end of the UTP (Unshielded Twisted Pair)
Category 5 cable into the RJ-45 connector that is
numbered from 1 to 8 of AOH-608 (or 1 to 5 of AOH-
605). Please orient the cable correctly and push it
into the connector until you hear a click.
2. Please make sure that the maximum length of the
cable from your computer to the hub does not exceed
100 meters.
3. After connecting to the hub, please check if the Link
LEDs on the adapter card and the hub (Link/Act) are
lit up.
C
ONNECTIONS
10