Advertisement
Tri Phase™
5-Pin XLR DMX Connectors.
connectors for DATA transmission in place of 3-pin. 5-pin XLR fixtures
may be implemented in a 3-pin XLR DMX line. When inserting stan-
dard 5-pin XLR connectors in to a 3-pin line a cable adaptor must be
used, these adaptors are readily available at most electric stores. The
chart below details a proper cable conversion.
3-Pin XLR to 5-Pin XLR Conversion
Conductor
3-Pin XLR Female (Out)
Ground/Shield
Data Compliment (- signal)
Data True (+ signal)
Not Used
Not Used
American DJ
- www.americandj.com - Tri Phase™ Instruction Manual Page 7
®
Some manufactures use 5-pin XLR
5-Pin XLR Male (In)
Pin 1
Pin 1
Pin 2
Pin 2
Pin 3
Pin 3
Pin 4 - Do Not Use
Pin 5 - Do Not Use
Set Up
Tri Phase™
ADDR -
DMX Address Setting.
1. Tap the either the MENU, UP, or DOWN buttons until "ADDR"
is displayed, press ENTER.
2. "1" will now be displayed and flashing. Press the UP or
DOWN buttons to find your desired address. Press ENTER to
set your desired DMX address.
SLND -
This will let you set unit as a master or slave in a
master/slave configuration.
1. Tap the either the MENU button until "SLND" is displayed,
press ENTER. "MSTR", "SL 1" or "SL 2" will be displayed.
2. Tap the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim and exit.
American DJ
- www.americandj.com - Tri Phase™ Instruction Manual Page 8
®
System Menu
Advertisement
