One (1) Year Limited Warranty SPANISH - pg. To the consumer, Rubbermaid Commercial Products, LLC (RCP) warrants to the original owner that this product is free from defects FRENCH - pg. in material and workmanship for a period of one (1) year from the date of the original purchase. If, within the one (1) year period, this product becomes defective when used as directed under normal conditions, RCP will either repair or replace the product—at our...
• DO NOT pick up any materials that are burning or • Fully assemble before operating. 1. Always use genuine Rubbermaid Commercial the same configuration as the plug. No adaptor smoking, such as cigarettes, matches, or hot ashes.
9V-WDHS-12 (hose) at 1-866-524-5233 for service and to order genuine cart frame diagonal support small foam filter utility tool bolt Rubbermaid Commercial Products replacement parts. caster bracket tank brace large foam filter floor nozzle lock washer casters vertical support...
ENGLISH Assembly Tools needed 10mm 13mm 10mm 13mm Attach axle support to cart frame using small screws, star Turn cart frame over. Note orientation of notch in axle support. Attach bolt, lock washer, and nut to wheel shaft support. Use Attach tank retaining bracket to wheel shaft support.
Page 6
ENGLISH Assembly (cont.) Notice: Cap nuts cannot be removed without causing damage to cap nuts and axle. Insert axle through wheel. Then insert axle into axle support. Place outer tank onto cart frame. Align drain cap with notch in Place float ball onto seal. Snap small float cage onto bottom of axle support.
ENGLISH Assembly Wet/Dry Selection (cont.) This vacuum cleaner has separate wet/dry tanks. This allows switching from wet pick-up to dry pick-up without having to empty the tank or change filters. Dry debris will collect in the inner tank and wet debris will collect in the outer tank. Ensure that the small foam filter and HEPA filter/HEPA foam sleeve are in place.
ENGLISH Wet Mode Operation Emptying Dry Tank Slide wet/dry selector right to expose wet port. Insert hose into “wet tank inlet” and turn clockwise to lock. Disconnect power cord from outlet. Release latches. Remove powerhead. Attach bent and/or straight wand and desired accessory. Plug power cord into outlet.
ENGLISH Liquid Overflow Protection Replacing HEPA Filter/ Emptying Wet Tank HEPA Foam Sleeve When either tank is full of liquid, the automatic shut-off mechanism will turn off vacuum cleaner motor. The automatic shut-off mechanism will also engage if the vacuum cleaner has been tipped over.
Replacing Small and Large Foam Filter Disconnect power cord from outlet. Release latches. Remove powerhead. Remove old small foam filter from standpipe in inner tank. Slide new small foam filter onto standpipe in inner tank. Note: The small foam filter must be in place whenever Optional the inner tank is in use.
Need help?
Do you have a question about the WD12.5 and is the answer not in the manual?
Questions and answers