Table of Contents
Advertisement
Figure 2
PLC-MCU4 Master Control
Unit Card
Figure 3
PLC-IROUT Infrared Output
Card
Encore Quick Setup Guide
The PLC-MCU uses non-volatile RAM for the program memory. No battery back-
up is necessary. However, as with any computer the use of a good surge suppressor
or UPS is very important. The MCU is shipped with 4 MB of nonvolatile program
memory and 4 MB of volatile memory.
The STATUS LED will blink when the PLC-MCU is online and ready for
communication. The LINK LED will blink when there is communication between
the PLC-MCU card and the PLB-CF10 cardframe.
PLC-IROUT Infrared Output Card
The PLC-IROUT (Figure 3) has four outputs for IR-controlled devices. The card will
queue commands if two outputs are already active. The card will handle up to a 10
MHz carrier. The carrier can be turned off with the software to allow control of
devices with a serial jack. The connectors are standard mini-phono connectors that
are compatible with standard Xantech emitters.
Introductions
3
Advertisement
Table of Contents
