American DJ Quad Phase HP User Instructions page 5

Quad Phase HP
ADDR -
DMX Address Setting.
1. Press the either the MENU, UP, or DOWN buttons until
"ADDR" is displayed, press ENTER.
2. "1" will now be displayed and flashing. Press the UP or
DOWN buttons to find your desired address. Press ENTER to
set your desired DMX address.
SLND -
This will let you set unit as a master or slave in a
master/slave configuration.
1. Press the either the MENU button until "SLnd" is displayed,
press ENTER. "MAST", "SL 1" or "SL 2" will be displayed.
2. Tap the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim and exit.
SOUN -
Sound Active mode.
1. Press the MENU button until "SOUN" is displayed, press
ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to activate sound active mode,
or "OFF" to deactivate sound active mode.
3. Press ENTER to confirm.
SENS
- Using this mode, you can set the sound sensitiv-
ity level. 0 for least sensitive, 100 for more sensitive.
1. Press the MENU button until "SENS" is displayed, press ENTER.
2. Using the UP or DOWN buttons adjust the sensivity level to your
desire.
3. When you found your desired level, press the ENTER, and then press
and hold the MENU button for at least 3 seconds to confirm.
ADJ Products, LLC - www.adj.com - Quad Phase HP Instruction Manual Page 9
System Menu Quad Phase HP
DNST
in case the DMX signal is lost, the operating mode chosen
in the setup is the running mode the fixture will go into when
the DMX signal is lost. You can also set this as the operat-
ing mode you would like the unit to return to when power is
applied.
1. Press the MENU button until "DNST" is displayed, press
ENTER.
2. Either "MAST", "BLND", or "LAST" will be displayed. Choose
an operating mode you would like the unit to start up in when
power is applied or the DMX signal is lost.
• MAST (Master Slave) - If the DMX signal is lost or power is
applied, the unit will automatically go into Master Slave mode.
• BLND (Blackout) - If the DMX signal is lost or power is applied,
the unit will automatically go into stand by mode.
• LAST (Last State) - If the DMX signal is lost the fixture will stay
in the last DMX set up. If power is applied and this mode is set,
the unit will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up
LED -
via the control board.
1. Press the either the MENU button until "LED" is displayed,
press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to switch on the LED, or "OFF"
to switch off the LED.
3. Press ENTER to confirm and exit.
- This mode can be used as a precaution mode, that
With this function you can switch the LED on or off
ADJ Products, LLC - www.adj.com - Quad Phase HP Instruction Manual Page 10
System Menu