Table of Contents
Advertisement
AP Deployment
Chapter 3
Connect the Power Injector
C
AUTION
W
ARNING
To connect the OAW-AP80M Access Point to a power source:
1.
Connect the Ethernet cable from the wireless Access Point to the RJ-45 port
labeled AP on the power injector.
2.
Connect a straight-through unshielded twisted-pair (UTP) cable from a local
LAN switch to the RJ-45 port labeled ENET on the power injector. Use
Category 5 or better UTP cable for 10/100BASE-TX connections.
N
:
The RJ-45 port on the power injector is an MDI port. If connecting
OTE
directly to a computer for testing the link, use a crossover cable.
18
Alcatel OAW-AP80M Access Point
Installation Guide
:
The Access Point's Ethernet port does not support Power
over Ethernet (PoE) based on the IEEE 802.3af standard. Do
not try to power the unit by connecting it directly to a
network switch that provides IEEE 802.3af PoE due to the
AP's maximum power draw requirement of 30 Watts. Always
connect the unit to the correct Power over Ethernet injector
module.
:
The power injector module is designed for indoor use only.
Never mount the power injector outside with the Access
Point unit.
031983-00
February 2006
Advertisement
Table of Contents
