Aiphone GT-AC Installation And Operation Manual page 8

Input the master code twice.
(Default :
Setting the key illumination time
(Default: 10 Sec.)
Input the setting code.
Illumination Blinking
Bleep
Inputting of illumination time
(ex.: 20 seconds)
10 - 99
Indicator is lit up at all times: 00
Illumination Blinking
Beep
- When the key is pressed, the green LED lights up, the buzzer beeps twice, and the system exits the setting mode.
(If the key is included in the user code and the master code, the system does not exit the setting mode.)
- You can continue the setting up operation by entering an arbitrary setting code.
8
)
Setting the relay output time
(Default: 3 Sec.)
When setting relay 1 When setting relay 1 When setting relay 2 When setting relay 2
Input the setting code. Input the setting code.
Illumination Blinking
Bleep
Inputting of relay output time
(ex.: 99 seconds)
01 - 99
Latched ( ) : 00
Illumination Blinking
Beep
· ( ) If the latched status has
been set and the door is
unlocked, it will not be locked
again until the user code is
entered (or the request to
exit/entry button is pressed, or
the key is pressed while
timer-linked unlocking is set).
· When the door is unlocked
during relay outputting
(including when latched), the
system cannot be switched to
the setting mode.
(orange) (green)
Illumination Blinking
Reset Settings
Input the setting code.
Illumination Blinking
Bleep
Illumination Blinks three times
Bleep, Bleep, Beep
· If the power is turned off and
the , , and keys are
pressed simultaneously while the
unlock 1 input status is active
(short circuit between terminals
PB1 and C), the settings can be
returned to their default values by
turning the power back on and
pressing the , , and
keys simultaneously for 3
seconds.
Bleep, Bleep
External output setting
(Default: OFF)
Input the setting code.
Illumination Blinking
Bleep
During lockout During lockout
During During During forced During forced
and forced and forced OFF OFF
Lockout Lockout entry output entry output
entry output entry output
Illumination Blinking
Beep
Indicator
goes out Blinking
Bleep,
Bleep
· When setting the external output,
do not set the relay 2 output to be
latched.