About This Manual - Omron SYSMAC WS02-NSFC1-E Setup Manual

About this Manual:

This manual describes the overview and installation of the WS02-NSFC1-E Face Plate Auto-Builder for
NS. The Face Plate Auto-Builder for NS is a software package used to automatically build project files
for the CS1W-LC001 Loop Control Unit and the CS1W-LCB01 and CS1W-LCB05 and CS1D-LCB05D
Loop Control Boards used with NS-series Programmable Terminals. These files are based on the tag
files created using CX-Process Tool.
The project files that are created are configured using the Face Plate Screens for the Loop Control Unit.
Please read this manual carefully and be sure you understand the information provided before
attempting to install and operate the Face Plate Auto-Builder for NS. Please read the following manuals
carefully and be sure you understand the information provided before setting up the Loop Control
Unit/Board and NS-series PT System
Related Manuals to the Loop Control Unit/Board
Product
WS02-NSFC1-E
Face Plate Auto-Builder
for NS
WS02-LCTC1-EV3
CX-Process Tool
WS02-LCTC1-E
CX-Process Monitor
CS1W-LC001
Loop Control Unit
CS1W-LCB01/05
CS1D-LCB05D
Loop Control Boards
CS1W-LC001
Loop Control Unit
CS1W-LCB01/05
CS1D-LCB05D
Loop Control Boards
Related Manuals to the NS-series PT
Product
NS-series PT
NS-series PT
NS-NSDC1-EV
NS-Designer
Failure to read and understand the information provided in this manual may result in
!WARNING
personal injury or death, damage to the product, or product failure. Please read each
section in its entirety and be sure you understand the information provided in the section
and related sections before attempting any of the procedures or operations given.
Manual name
Face Plate Auto-Builder for NS
Operation Manual
CX-Process Tool
Operation Manual
CX-Process Monitor
Operation Manual
Loop Control Unit
Operation Manual
Loop Control Board
Operation Manual
Loop Control Unit
Function Block
Reference Manual
Loop Control Board
Function Block
Reference Manual
Manual name
NS Series Setup Manual
NS Series Programming
Manual
NS-Designer Operation
Manual
Cat. No.
W418
W372
W373
W374
W406
W375
W407
Cat. No.
V072 Describes connecting the PT to the host and
peripheral devices, methods to setup communications
and operation, and procedures for maintenance.
V073
Describes the screen configurations, object functions,
and host communications for the PT.
V074 Describes operating procedures for the NS-Designer,
which is used to create the screens displayed on the
PT and transfer them to the PT. It includes screen
creation and transfer procedures.
Contents
Installation and operation
procedure for Face Plate
Auto-Builder for NS.
Installation and operation
procedures for the CX-Process
Tool.
Installation and operation
procedures for the CX-Process
Monitor.
Installation and operation
procedures for the Loop Control
Unit (except for function
blocks).
Installation and operation
procedures for the Loop Control
Boards (except for function
blocks).
Detaild information on function
blocks for Loop Control Units.
Detailed information on function
blocks for Loop Control Boards
Contents
vii