Copying The Enr Data To The Noise Figure Analyzer's Internal Memory - Agilent Technologies 346A Operating And Service Manual

Step 1. Power up the Noise Figure Analyzer and wait for the power-up sequence
Step 2. Insert the diskette into the floppy drive of the Noise Figure Analyzer.
NOTE
Step 3. Press the
Step 4. Press the
Step 5. Press the
Step 6. Set the From: Path: field to A:, use the down arrow key ( ) to highlight
Step 7. Press the
Step 8. Press the

Copying the ENR Data to the Noise Figure Analyzer's Internal Memory

Copying the ENR Data to the Noise Figure
Analyzer's Internal Memory
To copy the Noise Source ENR data from the diskette (A: drive) to the
Noise Figure Analyzer's internal memory (C: drive) proceed as follows:
to complete.
Do not insert the diskette into the Noise Figure Analyzer until the
power-up sequence is complete.
key and press the
File
menu key.
Copy>
The file system is now presented to you.
menu key to set the file type and format to ENR.
ENR
the ENR file and the
The filename you are going to copy now appears in the From: Name:
field.
key to navigate to the To: Path: field and ensure it is set
Tab
to C:
key to copy the selected file from the diskette (A:) to the
Enter
Noise Figure Analyzer's internal memory (C:).
When the file is successfully copied a message, for example
A:A0100364.ENR file copied appears on the status line of the display.
For details on the ENR filename format, see "ENR filename format" on
page 38.
Chapter 3
File Manager
key to select it for copying.
Select
Using the ENR Data Diskette
menu key.
41