Software Setup Troubleshooting; Installing Additional Software - AgfaPhoto AS 1300 User Manual

1. Insert the document face down into the scanner. Align the document to the
arrow sign on the right of the scanner.
2. Press the SCAN button on the scanner. The scanning starts immediately.
3. When the scan completes, click My Document folder on your desktop to find a
folder named as DigiScan.
4. If an image is saved in the DigiScan folder, your scanner is working properly.
If the test failed in any way, please refer to "Appendix A:
Troubleshooting" section of this manual and follow the instructions
therein.
Attention

Software Setup Troubleshooting

Carefully review the steps outlined in this guide and the Quick Guide that
accompanied your scanner.
If you are still having problems, please check that:
You have 450 MB of free space on your hard disk drive.
The scanner is plugged in and has power.
You are using the USB cable supplied with the scanner.
The square end of the USB cable is plugged into the rear of the scanner.
The rectangular end of the USB cable is plugged into the back of your
computer.
If you deviated from the installation procedures defined in this manual, please
unplug the USB cable from the scanner and reinstall the software from the CD-ROM.
To reinstall your scanner's software, click "Start", "Run", then type "D:\Install (where D
represents the letter of your CD-ROM drive)". Carefully follow all the installation
instructions presented in the Setup Wizard. Reboot your computer when prompted,
and plug the USB cable back into the scanner while your computer is still turned on.

Installing Additional Software

Your scanner is TWAIN compliant and functions with virtually all available TWAIN
compatible software. If you purchase additional software to be used with your scanner,
please make sure that it conforms to the TWAIN standard.
10