Nokia N80 User Manual page 99

Call settings
Send my caller ID—You can set your phone number to be
displayed to (Yes) or hidden from (No) the person to whom
you are calling, or the value may be set by your network
operator or service provider when you make a subscription
(Set by network) (network service).
Call waiting—If you have activated call waiting (network
service), the network notifies you of a new incoming call
while you have a call in progress. Set the function on
(Activate) or off (Cancel), or check whether the function
is activated (Check
Reject call with SMS—Select
to a caller informing why you could not answer the call.
See "Answer or decline a
Message text—Write a text to be sent in a text message
when you reject a call.
Image in video call—If video is not sent during a video call,
you can select a still image to be displayed instead.
Automatic redial—Select On, and your device makes a
maximum of 10 attempts to connect the call after an
unsuccessful call attempt. To stop automatic redialing,
press .
90
status).
Yes to send a text message
call", p. 57.
Copyright © 2007 Nokia. All rights reserved.
Summary after call—Activate this setting if you want the
device to briefly display the approximate duration of the
last call.
Speed dialling—Select On, and the numbers assigned to
the speed dialing keys (
pressing and holding the key. See also
number", p. 53.
Anykey answer—Select On, and you can answer an
incoming call by briefly pressing any keypad key,
except , , , and
Line in use—This setting (network service) is shown only if
the SIM card supports two subscriber numbers, that is,
two phone lines. Select which phone line you want to use
for making calls and sending text messages. Calls on both
lines can be answered irrespective of the selected line.
If you select Line 2 and have not subscribed to this
network service, you will not be able to make calls.
When line 2 is selected,
Tip! To switch between the phone lines, press and
hold in the standby mode.
Line change—To prevent line selection (network service),
select Disable if supported by your SIM card. To change
this setting, you need the PIN2 code.
- ) can be dialed by
"Speed dial a phone
.
is shown in the standby mode.