I n t r o d u c t i o n 1. Introduction Nokia Camera Flash enables you to take photos and video clips in poor lighting conditions. Nokia Camera Flash can be connected to compatible Nokia camera phones, such as the Nokia 7610 phone.
Read this user guide carefully before using Nokia Camera Flash. More detailed information is provided in the user guide of your own phone. Do not use this user guide in place of the user guide for the phone, which provides important safety and maintenance information.
When the indicator light is red, the battery must be replaced. ■ Using Nokia Camera Flash 1. Connect Nokia Camera Flash to the phone Pop-Port. 2. To take a picture, see the user guide for the phone. The indicator light blinks green while the flash charges.
T r o u b l e s h o o t i n g 3. Troubleshooting • Q: Why do I receive a message that the enhancement is not supported when I connect Camera Flash to a compatible phone? A: Camera Flash must be correctly connected to your phone.
T r o u b l e s h o o t i n g A: A blinking green LED indicates the flash is charging and is not ready for use. A steady green indicates the flash is charged and is ready for use.
B a t t e r y i n f o r m a t i o n 4. Battery information This device is intended for use when supplied with power from a CR2 3V, Lithium battery. The use of any other types may invalidate any approval or warranty, and may be dangerous.
B a t t e r y i n f o r m a t i o n Leaving the battery in hot or cold places, such as in a closed car in summer or winter conditions, will reduce the capacity and lifetime of the battery. Always try to keep the battery between 15°C and 25°C (59°F and 77°F).
C A R E A N D M A I N T E N A N C E CARE AND MAINTENANCE Your device is a product of superior design and craftsmanship and should be treated with care. The suggestions below will help you protect your warranty coverage.
C A R E A N D M A I N T E N A N C E • Do not store the device in cold areas. When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards.