Niles SW10 Installation Manual page 10

10" & 12" high-powered subwoofer for use in music or home theater systems

Hide thumbs Also See for SW10:

Table of Contents

SIGNAL CONNECTORS AND POWER CONTROLS

The SW10 and SW12's signal connectors and power controls are located on the unit's rear panel,

as shown in Figure 2. They function as follows:

NOTE: SEE APPLICATIONS STARTING ON PAGE 10 FOR DETAILED WIRING CONNECTIONS FOR

YOUR APPLICATION.

��

Figure 2. The SW12's rear panel contains the subwoofer's signal connectors

and power controls. (SW12 Shown - SW10 similar)

1. TRIGGER: For external power triggering, use a mini (3.5 mm) mono plug to connect the

IN jack to a power on/off trigger signal from a home theater surround sound processor

or other voltage. Power on is 3 to 30 Vdc (or Vac). Power off is 0 Vdc (or Vac). Use the

OUT jack to pass the TRIGGER signal (at the same voltage level of the trigger input) to

another SW10 and SW12 or other equipment in your system. THIS JACK SHOULD NOT

BE USED TO POWER OTHER EQUIPMENT.

NOTE: FOR A SYSTEM NOT EQUIPPED WITH A POWER TRIGGER OUTPUT, CONSIDER USING A NILES

12-VOLT POWER SUPPLY (FG01035) AS A TRIGGER SIGNAL THAT IS ACTIVATED VIA A SWITCHED AC

OUTLET ON THE RECEIVER. SEE FIGURE 6 ON PAGE 13 FOR CONNECTION DETAILS.

��

�

��

�

��

�

��

�

��

�

��

Table of Contents

Show Quick Links

Table of Contents

Sw12