Virtual.remote.controller; E-Mail.notification.function - Mitsubishi HD8000 User Manual

ProjectorView (continued)
VIRTUAL REMOTE controller
Put.a.checkmark.in.the.box.of.the.Virtual.remote.enabled.on.the.ProjectorView.main.screen,.and.click.the.VIRTUAL.
REMOTE.button..The.following.Virtual.Remote.window.appears..
For.the.functional.descriptions.of.each.button,.see.the.user.manual.of.the.projector.
E-mail notification function
In. case. of. an. error. or. abnormality. in. the. projector,. e-mail. notification. is. automatically. sent. to. the. designated.
address.to.notify.of.the.error.or.abnormality..
To.use.this.function,.perform.the.following.steps..
. Enable.the.LAN.control.function..(See.page.0.).
2. Set.the.SMTP.IP.address,.E-mail.address,.E-mail.host,.and.E-mail.from.
Once.the.above-mentioned.items.are.set,.the.e-mail.notification.function.remains.enabled.even.when.the.browser.
(ProjectorView.screen).is.closed..
Example.of.notification:.Alert.on.lamp.life.end
ProjectorView Alert:
The lamp has reached its maximum usage. Replace the lamp and reset lamp counter. See user guide for complete
instructions.
Projector name : abc
Projector model : HD8000
Projector location : 10Factory-5F
Serial number : 12345
Operating hours : 2146 hours and 43 minutes
Lamp hours : 4000 hours and 0 minute
Installation date: 2008/01/01
Last lamp replacement date: 2008/01/01
Last maintenance date: 2008/01/01
(Note)
•. In.case.of.a.command.error,.e-mail.notification.isn't.sent..
•. When.the.LAN.control.is.enabled,.serial.RS-232C.commands.may.not.be.transmitted..
•. You.can't.control.the.LAN/serial.RS-232C.commands.for.about.0.seconds.after.turning.on.the.main.power.of.the.
projector..
•. When.commands.for.LAN.control.and.for.RS-232C.control.are.issued.at.the.same.time,.the.LAN.control.command.
overrides.the.RS-232C.control.command..
•. While.a.test.pattern.is.displayed.or.a.password.is.entered,.you.can't.change.the.lamp.mode.and.enable.and.disable.
the.MUTE.function..
•. Response.may.be.delayed.depending.on.the.operating.state.of.the.projector..
•. The.DHCP.mode.may.not.operate.with.certain.devices.(routers.etc.)..
•. When.you.turn.on.the.projector.by.pressing.the.ON/OFF.button.on.the.ProjectorView.main.screen,.other.commands.
are.not.accepted.for.about..minute..
•. E-mail.notification.is.issued.twice:.at.the.time.of.occurrence.of.an.alert/error.and.2.hours.after.the.occurrence..
To.use.the.e-mail.notification.function,.configure.the.initial.settings.in.advance.as.described.on.the.next.page..
EN-4