Vicks Germ-Free V790 Instructions Manual page 8

Warm mist humidifier
Table of Contents

Advertisement

Available languages

Available languages

11. After base is totally cleaned and dried, replace mineral absorption pad. Place
nozzle on base and rotate clockwise until it locks. Place Top Housing on
Main Housing and rotate lock wheels until it locks in place.
12. Replace tanks. Plug in the unit and resume normal use.
CHANGING THE UV BULB
1. If the "REPLACE UV BULB" indicator illuminates during normal use, it is time
to change the UV bulb, which is a special 3.5W bulb.
2. Turn the POWER switch to the "OFF" position, unplug it and allow it to cool.
3. Remove the water tanks from the base of the humidifier. Remove Top
Housing by rotating (2) lock wheels. Remove nozzle by rotating it counter
clockwise and lifting up.
4. Place the base of the humidifier over
the sink and tilt the unit to remove
any remaining water.
5. Carefully turn the base of the humidifier
over and place it upside down on a flat
level surface. You will see a door at
back of unit that is closed with two
Phillips head screws.
6. Using a Phillips head screwdriver,
carefully turn the screws counter-
clockwise until the screws separate
from the door.
7. Open the door, by pulling forward. The UV light bulb will be visible. Pull the
door out the minimum amount to have access to unscrew bulb from socket.
8. Take a replacement 3.5W UV bulb that you purchased from Kaz, Inc. or
another supplier and change the bulb. To prolong the life of the bulb, limit
your direct contact with the glass of the bulb by using a cloth or tissue to
screw it into place.
9. When the new bulb is in place, close the door and replace the screws by
using your Phillips head screwdriver and rotating them clockwise until they
are just tight. DO NOT OVER TIGHTEN.
WARNING
10.
DO NOT view illuminated bulb directly because eye damage may occur.
11. Turn the unit upright, place the top housing, nozzle and water tanks on top of
the base of the humidifier, plug the unit in, and push the POWER switch to
the ON position. The "REPLACE UV BULB" indicator should no longer be lit.
IMPORTANT NOTE: Even though you will not receive maximum germicidal
effects, you can still use your humidifier until the replacement bulb arrives.
NOTE: You will hear a rattling sound and notice a small round object inside your
bulb. This is normal. Your bulb is fully operational.
Lamp contains mercury. Manage in accordance with disposal laws.
Hg
See www.lamprecycle.org or call 1-800-895-8842
-
DO NOT turn power on, while UV lamp door is open, and
UV
BULB
UV LAMP
DOOR
SCREW
UV LAMP
DOOR
UV
BULB
SCREW

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents