Miele KF 7564 S ed-3 Operating And Installation Manual page 41

The appliance can be installed in a
kitchen run. To match the height of the
rest of the kitchen, the appliance can
be fitted with a suitable top box a.
A ventilation gap of at least 50 mm
depth must be allowed for behind the
appliance for air to circulate.
The cross section of the air outlet under
the room ceiling must be at least 300
2
cm to ensure that air can circulate
without hindrance. Otherwise the appli-
ance has to work too hard resulting in
an increase in electricity consumption.
The larger the cross section, the more
efficient the appliance.
The air inlet and outlet must not be
covered or blocked in any way.
They should be dusted on a regular
basis.
When built into a kitchen run (max.
depth 580 mm) the appliance can be
installed directly next to a kitchen furni-
ture housing unit. The appliance door
b will protrude in front of furniture
fronts at the sides by 34 mm and by 51
mm in the middle of the door. This en-
ables the doors to be opened and shut
without being obstructed.
When
tance of approx. 36 mm is needed on
the hinge side between the wall and the
appliance, so that the doors and the
handles have sufficient space for open-
ing.
When
d or if
appliance and the wall, please note the
following:
^ Ensure that the doors have sufficient
space for opening fully after the ap-
pliance has been secured.
^
would damage insulated parts of the
appliance.
^ To secure the appliance to adjoining
kitchen furniture use self-tapping
screws. The
not exceed
tion.
c a dis-
is fitted between the
as this
of the screw must
. See small illustra-
41