Table of Contents
Advertisement
^ Pull bearing bush d downwards out
of hinge bracket e and refit it from
above into the hinge bracket.
^ Use a screwdriver to remove spacer
g and refit it on the opposite side.
^ Remove covers m at the front and
slide off to the side.
^ Unscrew handle k. Refit handle and
stoppers l on the opposite side.
^ Slide covers m into position making
sure they engage correctly.
^ Remove stoppers j from door
bearing bushes in the doors and refit
on the opposite side.
^ Hang the upper appliance door on
hinge pin c, and close the appliance
door.
^ Push middle hinge pin f from below
through hinge bracket e into the
upper appliance door.
^ Check that the door is correctly
aligned. If necessary align it using
the long slots in hinge bracket e.
^ Hang the lower door in hinge bracket
e then close the appliance door.
In the following illustration the lower
door is not shown in the closed
position to make it easier to see
what happens next.
46
^ Turn door support b around, pull
hinge pin a out, and refit on the
opposite side.
^ Fit both parts into hinge plate f. To
do this push hinge pin a through
hinge plate f into door support b.
Swing door support out, push
upwards and re-assemble with screw
c.
^ Align the lower door with the
appliance housing using the long slot
in hinge plate f. Then tighten screw
c.
^ Refit plinth fascia d pushing it firmly
into position.
^ With the lower door open, secure
cover e to the front of the plinth
fascia.
Hide quick links:
Advertisement
Table of Contents
