^ Unscrew part i from hinge plate g,
rotate it by 180° and refit into the hole
on the opposite side of the hinge
plate.
^ Refit cover cap e in the other hole.
^ Unscrew threaded pin d fully using
the allen key supplied.
^ Fit the threaded pin d into hinge
plate on the opposite side, until it is
flush with the hinge plate.
^ The end must protrude sufficiently
through the hinge pin hole such that
the guide on the hinge pin will fit over
it later on (see following illustration).
^ Remove cover h.
^ Unscrew and remove screw i and
refit it into the outer hole of the
opposite side.
^ Rotate cover h by 180°, and fit it into
the holes on the other side.
Changing the door hinging
^ Screw hinge plate g into position on
the opposite side using the two outer
long slots only. To make it possible to
align the door later, do not replace
the centre screw at this stage.
^ Important. Screw the adjustable foot
c into hinge pin a as far as it will go.
^ Refit the hinge pin a together with
disc b and adjustable foot c such
that the guide on the end of the pin
fits over the threaded pin. Then
tighten it.
^ Then tighten threaded pin d.
53