Table of Contents
Advertisement
If you have adjusted the temperature,
wait for approx. 6 hours if the
appliance is not very full and for
approx. 24 hours if the appliance is
full before checking the temperature
display as it will take this long for the
display to give an accurate reading. If,
after this time, the temperature is still
too high or too low, you will need to
adjust it again.
Temperature range
The temperature can be adjusted from:
-14 °C to -28 °C
The ambient temperature in the room
and the installation location can affect
the time it takes for the appliance to
reach the lowest temperature. If the
ambient temperature is too high, the
appliance may not reach the lowest
temperature.
Temperature display
During normal operation, the
temperature display on the control
panel shows the temperature in the
warmest part of the appliance.
If the temperature in the appliance is
not within the range that the appliance
is able to display (below 0°C), only bars
will light up in the temperature display.
The temperature display will flash if
– a different temperature is being set,
– the temperature has risen too much,
as a warning that the appliance is no
longer cold enough.
The correct temperature
This loss of coldness is no cause for
concern in the following circumstances:
– when the door has been left open for
a while, e.g. for removing or storing a
large amount of food,
– when fresh food is being frozen.
As soon as the temperature has fallen
to approx. -10 °C, the temperature
display ceases to flash and lights up
constantly.
However, if the temperature remains
above -18 °C for a long time, check that
the frozen food has not started to
defrost. If it has, make sure that the
food is safe to use and, if it is, then use
it as soon as possible.
Temperature display brightness
The appliance is supplied with the
brightness of the temperature display
set as low as possible. However, if the
door is opened, a setting changed or if
the alarm is sounding, the temperature
display will appear much brighter.
The level of brightness can be
adjusted:
^ Press and hold the Super freeze
button for approx. 5 seconds.
The SF indicator light will start to flash
and a C will appear in the temperature
display.
15
Hide quick links:
Advertisement
Table of Contents
