Miele G 653 Installation Instructions Manual page 16

When fitted the door front can be ad-
justed up to a maximum of 2 mm up-
wards or downwards to match adjoining
unit fronts.
^ Open the dishwasher door slightly.
^ With the door open, press the front
panel on one side against the door
outer panel.
^ Adjust the height of the door front on
this side using the lower recessed
adjusting screw (TORX T20).
higher = turn clockwise
lower = turn anti-clockwise
^ Then secure the door front on this
side by tightening the upper re-
cessed fixing screw (TORX T20) at
the side of the machine door outer
panel.
^ Repeat the process on the other side
of the door.
16
^ Close the dishwasher door.
^ Check the alignment of the door
panel again.
^ If it is not correctly aligned you may
need to loosen the screws and re-
adjust it to the correct alignment.
Once satisfied that the alignment is cor-
rect:
^ Open the dishwasher door.
^ Tighten all fixing screws (upper
screws, TORX T20) at the sides.
^ Plug fixing screw and height adjust-
ment screw recesses with the plastic
stoppers supplied.