Operation
c
Touchpads
1/2 allow you to store in
memory programmes which are fre-
quently used.
There are two memory stores where fre-
quently used programmes can be re-
corded.
You can store all the operating functions,
e.g. grilling, combination functions, and
automatic programmes.
A programmed sequence of functions
can also be stored.
Each memory store can be used again
with a different programme.
Proceed as for setting the operating
mode.
Do not however press the
button at the end, instead select
1 or 2 to store the setting.
The code number of the stored pro-
gramme will appear in the display,
then the time of day will reappear.
Press the relevant storage touchpad,
c
1 or 2.
The stored settings for the operating
function appear in the display area
step by step.
If you press the START button immedi-
ately after selecting the stored pro-
gramme 1 or 2, this will avoid the whole
sequence showing in the display area.
Storing a new programme will auto-
matically delete any previously
stored programme.
In the event of a power cut the
stored programmes will be deleted,
and will need to be re-entered.
h
START
c
Make a note of the programme se-
quences, so that they are available
for use when you need them.
h
Press the
START touchpad.
In the display area the time counts
down in one second steps. An
audible tone sounds at the end and
the time of day reappears.
31