Table of Contents
Advertisement
Safety instructions for
installation
Fit the wall units and extractor hood
before fitting the hob to avoid
damaging the appliance.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This equipment may only be used in
mobile installations such as ships,
caravans, aircraft etc. if a risk
assessment has been carried out by a
suitably qualified engineer.
~
The hob may not be built in over a
fridge, fridge freezer, freezer,
dishwasher, washing machine or
tumble dryer.
~
After installing the hob, ensure that
the connection cable cannot come into
contact with the underside of the
appliance. Make sure that there is no
mechanical obstruction, such as a
drawer, which could damage it.
~
Observe carefully the safety
distances given on the following pages.
~
Do not use any sealant except
where expressly instructed to do so.
The sealing strip under the edge of the
top part of the hob provides a sufficient
seal for the worktop (see section
"Sealant").
All dimensions in this instruction booklet
are given in mm.
Installation
47
Hide quick links:
Advertisement
Table of Contents
