Screwing Out And Adjusting The Feet; Building Under A Continous Worktop / In A Kitchen Run - Miele WT 2780 wpm Operating Instructions Manual

Screwing out and adjusting the feet

The four adjustable screw feet are used
to level the machine. All four feet are
screwed in when the machine is
delivered.
^ Using the spanner supplied turn
counter nut 2 in a clockwise
direction. Then turn counter nut 2
together with foot 1 to unscrew.
^ Use a spirit level to check the
machine is standing level.
^ Hold foot 1 securely with a pipe
wrench. Turn counter nut 2 again
using the spanner supplied until it
sits firmly up against the housing.
,
All four counternuts must sit
firmly up against the housing. Please
also check this for the feet which did
not need adjustment. Otherwise
there is the danger of the machine
moving about.
Installation and connection
Building under a continous worktop /
in a kitchen run
The fitting of building under kits
must only be undertaken by
qualified and competent persons, in
accordance with the instructions
supplied with the kit.
If you wish to push your machine under
a worktop and there is space to do this
without removing the lid, the
conversion kit is not necessary.
Otherwise it is essential.
– The building under conversion kit*
includes a cover plate which must be
fitted to ensure electrical safety.
– When installing under a 900/910 mm
high worktop a raising kit* is
required.
– Connections for electricity, water and
drainage should be installed in such
a way that they remain accessible
when the machine is in place.
Fitting instructions are supplied with the
conversion kit.
All parts marked * are available from
your Dealer, the Miele Spare Parts
Department or via the internet at
www.miele-shop.com.
71