Loop Points; Cue Points; Phase Grid - M-Audio Torq Conectiv User Manual

Loop Points

The Loop Points of the song (set with the Loop In/Out buttons or the QuickCue buttons) will be shown on the Waveform.
The looped area of the music will appear in a lighter shade compared to the rest of the waveform.

Cue Points

If you've used the Cue button or QuickCue buttons to place various Cue Markers in the song, you will see them here. The
QuickCue markers have numbers above them (corresponding to the assigned QuickCue button) and the standard Cue
Point appears as an orange line.

Phase Grid

Torq superimposes a Phase Grid over the Scrolling Waveforms to indicate the location of the beats in a song. The thicker
lines in the Phase Grid indicate the locations of the downbeats in the music. Torq will attempt to position the Phase Grid
in the proper location as part of the analysis when loading a song into a Deck. Torq uses the position of the Phase Grid to
properly synchronize the song.
Torq User Guide Torq User Guide
» »
21 21
Chapter 4 Chapter 1