Table of Contents
Advertisement
D
E
G
J
K
L
blade bolt
Starting and Stopping
F
H
1
How to Mow
Adjusting the Cutting Height
blade
cutting
height
spacers
fan
To Start your Lawnmower
1.
Connect female extension cable connector to the
back of the switchbox. (Turbo Lite 350/400 only)
(D)
2.
Form loop in mains cable and push the loop
through the slot as illustrated in picture (E)
3.
To secure, position loop over the hook and pull the
cable back through the slot as illustrated in picture
(F).
4.
Connect plug to mains and switch on.
5.
Move handle to the mowing position.
6.
To prevent a ring being cut in your lawn, tilt your
lawnmower slightly (G).
The switchbox is provided with a lock-off button
(H1) to prevent accidental starting.
Press and hold the lock-off button (H1) on the
7.
switchbox, then squeeze one of the Start/Stop
levers towards the upper handle (J).
8.
Continue to squeeze the start/stop lever towards
the upper handle and release the lock-off button.
9.
When the lawnmower has reached full speed gen-
tly lower it onto the lawn.
•
NOTE
There are two start/stop levers fitted. Either
one can be used for starting the lawnmower.
•
IMPORTANT
Do not use the start/stop levers intermittently
To Stop your Lawnmower
1.
To prevent a ring being cut in your lawn, tilt your
lawnmower slightly (G).
2.
Release the pressure on the Start/Stop lever.
1.
Start mowing the edge of the lawn nearest to the
power point so the cable is laid out on the lawn you
have already cut. (K)
2.
Cut your grass twice a week during the growing
season, your lawn will suffer if more than a third of
its length is cut at one time.
Do Not Overload Your Mower
Mowing long thick grass may cause the motor speed to
drop, you will hear a change in the motor sound. If the
motor speed drops you may overload your lawnmower
which may cause damage. When mowing in long thick
grass a first cut with the cutting height set higher will
help reduce the load. See Adjusting the Cutting Height.
Always handle the blade with care - sharp edges
could cause injury. USE GLOVES. Never use more
than 3 Cutting Height Spacers for the Turbo Lite 330
OR 4 Cutting Height Spacers for the Turbo Lite
350/400. Spacers must only be fitted between the
blade and the fan and NEVER between the blade
and the bolt.
1.
Remove the blade bolt, and blade as described in
Removing the Blade and Fan.
For a Lower Cut - Add spacers to a maximum of 3
2.
for Turbo Lite 330, or 4 for Turbo Lite 350/400.(L)
For a Higher Cut - Take spacers away.
3.
Refit the blade as described in Fitting the Blade
4.
and Fan.
Hide quick links:
Advertisement
Table of Contents
