Table of Contents
Advertisement
Prestige 645M-A1 ADSL Bridge
2.6
Turning On Your Prestige
At this point, you should have connected the ADSL line, the Ethernet port and the power port to the
appropriate devices or lines. Push in the power button (located on the back of your Prestige) to turn on your
Prestige.
2.7
Configuring Your Prestige For Internet Access
Configure your Prestige for Internet access using:
SMT (System Management Terminal). Access the SMT via LAN or WAN using Telnet.
2.7.1 Connect to your Prestige Using Telnet
The following procedure details how to telnet into your Prestige.
Step 1.
In Windows, click Start (usually in the bottom left corner), Run and then type "telnet 192.168.1.1"
(the default IP address) and click OK.
Step 2.
Enter "1234" (the default) in the Password field.
Step 3.
After entering the password you will see the main menu.
Please note that if there is no activity for longer than five minutes (default timeout period) after you log in,
your Prestige will automatically log you out. You will then have to telnet into the Prestige again.
2.7.2 Entering Password
The login screen appears after you press [ENTER], prompting you to enter the password, as shown next.
2-6
Figure 2-4 Connecting the Microfilter
Hardware Installation & Initial Setup
Advertisement
Table of Contents
Troubleshooting
