Rack Mounting; Getting Connected - Zoom RFX-1000 Operation Manual

Rack Mounting

The RFX-1000 is compatible with international 19-inch rack standards (EIA, DIN). Because the unit has been designed
for rack installation, it is preferable to operate the unit in this way, rather than simply placing it on a table or similar.
Align the four screw holes with the rack screw holes and securely fasten the unit to the rack with screws.
• The RFX-1000 uses a metal frame,
making the unit heavier than it might
Caution
seem at first glance. While installing the
unit in a rack, carefully support the
weight of the unit until all screws are
securely tightened. Otherwise the unit
may drop, possibly causing injury to
persons or damage to itself or to other
equipment.
• Do not directly stack the unit on top of
other equipment. Otherwise heat may

Getting Connected

Basic Connections
RFX-1000 is connected to an electronic instrument, microphone, and mixer or other audio device
Microphone
Always turn the power to all components off before making any connections.
Otherwise there is a risk of hearing damage or equipment damage by sudden
Caution
loud noise.
Insert Connection
This is an example for inserting the RFX-1000 between the sound source and a playback system or multi-track recorder
(MTR). A stereo source should be connected to the INPUT L/MONO and R jacks. A mono source should be connected to
the L/MONO jack only.
In this example, the signal from the mic or the instrument is effect processed by the RFX-1000 and then sent to the
playback system or MTR. The balance between original sound and effect sound is adjusted at the RFX-1000.
Rhythm machine, synthesizer, or similar
Guitar effect
Guitar
Microphone
4
• Before installation, always unplug any
• Make sure that the rack in which the unit is
RFX-1000 front panel
R
L
INPUT
OUTPUT
R
L/MONO L R
MIC IN
lead to a fire risk or cause performance
degradation.
connecting cables and the AC adapter cable.
Otherwise the equipment or the cables may be
damaged.
installed is placed on a firm, solid surface, so
that it cannot shake or topple over. Otherwise
there is a risk of injury to persons or damage
to the unit or to other equipment.
MIC IN
RFX-1000
RFX-1000 rear panel
FS01
FS01
INPUT
Mixer or
amplifier/speaker
ZOOM RFX-1000
FS01