Download Print this page

Zeon IN4502 CALIBRE 458 Operation Manual

Advertisement

Quick Links

Calibre 458
Automatic Movement Operation Manual
Automatic watches can be used only by those who are reasonably active as the automatic
winding relies on a regular movement of the wrist. The watch must be given an initial manual
wind of 8 to 10 turns and provided that it is worn on the wrist for a minimum of 8 hours each
day it will continue to function indefinitely and may be taken off the wrist for a maximum period
of 30 hours. If this period is exceeded the movement will stop and another manual wind will be
necessary. It must be remembered that when worn in bed the movement of the wrist is
insufficient to operate the automatic winding.
Time Stand Accuracy
1)
21,600 beats per hours
2)
Accuracy between -30 to +30 seconds per day worn under normal conditions.
Butterfly Strap Adjusting Instruction
Firstly, open the butterfly buckle and then pull out the pin. Adjust the strap to the required
length, and then push back the pin into the correct hole. Finally, close the butterfly buckle until
it clicks into place.
Page 1
Instruction for Time Setting
1)
Pull the crown out to First position and turn the crown anti-clockwise until the
correct day of the week is achieved. The day and date will now be correct, now set
the time but make sure the time is set onto am or pm. Finally push the crown back
to the normal position.
Power Reserve Dial
This watch has a Power Reserve Indicator Dial to show amount of power remaining within the
movement. Wind the watch until the indicator hand on Power Reserve dial reaches the "40"
position, which means that it is now in full power. If the watch is not in use and Power Reserve
Indicator hand showing "40" position the watch will continue to function until the indicator
finally reaches "0". At this stage the power indicator needs to be rewound until it reaches "40"
position stage.
Page 4
Water Resistance Table
Level of
Suitable for
Can
Suitable for
Suitable for
Water
Everyday
withstand
Swimming
Pool Size
Resistance
use
accidental
splashing
None
Yes
No
No
No
3 ATM
Yes
Yes
No
No
(30m/
100ft
5 ATM
Yes
Yes
Yes
Yes
(50m/
150ft)
10 ATM
Yes
Yes
Yes
Yes
(100m/
300 ft)
Water resistance is not permanent. In the course of time, the gaskets of the case and
crown may become worn and reduce the water resistance of your watch. We recommend
the periodic checking
Normal Crown – always make sure it is pushed fully into case
Screw down Crown – tighten screw down crown completely to screw lock position.
To maintain water –resistance crystal, crown and case must remain intact
Exposure to Salt Water
If your watch is designed for sports or working in the water and it becomes exposed to salt
water or significant amounts of perspiration, it should be rinsed in fresh water and dried
thoroughly with a soft dry cloth.
Important
Buttons must not be operated while in contact with water
Page 2
Calibre 458
IN4502
Page 5
Functions
-
Hours
Suitable
Suitable for
for
high board
-
Minutes
snorkelling
diving or sub-
-
Seconds
or water
aqua diving
sports
-
Day of the week dial
-
Date of the Month and Month
No
No
-
Manual Year dial
No
No
Power Reserve Indicator Dial
-
-
Water Resistance – Check the back of the watch and refer to the Table.
No
No
Instructions for Month and Year Setting
Yes
No
1)
By using a pointed device press Button C until the correct year is achieved.
2)
To set the month press Button A until the correct month is achieved.
Instructions For Setting Day and Date
1)
To achieve an accurate day of the week setting, by using a pointed device press
button D until a day prior to the day you required is achieved i.e. if today is
Wednesday then set in onto Tuesday
2)
To achieve an accurate date setting, press button B until a date prior to the date
you required is achieved. i.e. if today is the 16th then set it onto the 15th.
If the date is set between 10:00 PM and 02:00 AM, the date will not change
correctly.
The day and date is changed during the period from about 10:00AM to about
02:00AM.
Page 3

Advertisement

loading

This manual is also suitable for:

Calibre 458