Advertisement
Quick Links
Calibre 633
Automatic Movement Operation Manual
Automatic watches can be used only by those who are reasonably active as the automatic
winding relies on a regular movement of the wrist. The watch must be given an initial manual
wind of 8 to 10 turns and provided that it is worn on the wrist for a minimum of 8 hours each
day it will continue to function indefinitely and may be taken off the wrist for a maximum period
of 30 hours. If this period is exceeded the movement will stop and another manual wind will be
necessary. It must be remembered that when worn in bed the movement of the wrist is
insufficient to operate the automatic winding.
Time Stand Accuracy
1)
21,600 beats per hours
2)
Accuracy between -30 to +30 seconds per day worn under normal conditions.
Page 1
Instructions for setting Day, Date and Month
Important
• Do not set the day & date between 06.00 PM and 06.00 AM, as this may cause
damage to the movement.
• At the end of the each month the date & month will required to be changed
manually.
1)
To achieve an accurate date setting, unscrew and pull crown out to First Position
and turn the crown anti-clockwise until a date prior to the date you required is
th
achieved i.e. if today is the 16
then set it onto the 15
2)
To achieve an accurate day setting, unscrew and press button A until a day prior
to the day you require is achieved, i.e. if today is Wednesday then set it onto
Tuesday, and screw the button back to its position.
3)
Unscrew and press button B to set correct month and screw the button back to
its position.
4)
Pull the crown out to second position and turn the crown clockwise until the day
and date is corrected.
5)
Once the day & date are corrected, set the correct home time by turning the
crown clockwise but make sure the time is set onto AM or PM.
6)
Finally push and screw the crown back to normal position.
Page 4
Water Resistance Table
Level of
Suitable for
Water
Everyday
Resistance
use
None
Yes
3 ATM
Yes
(30m/
100ft
5 ATM
Yes
(50m/
150ft)
10 ATM
Yes
(100m/
300 ft)
Water resistance is not permanent. In the course of time, the gaskets of the case and
crown may become worn and reduce the water resistance of your watch. We recommend
the periodic checking
Normal Crown – always make sure it is pushed fully into case
Screw down Crown – tighten screw down crown completely to screw lock position.
To maintain water –resistance crystal, crown and case must remain intact
Exposure to Salt Water
If your watch is designed for sports or working in the water and it becomes exposed to salt
water or significant amounts of perspiration, it should be rinsed in fresh water and dried
thoroughly with a soft dry cloth.
Important
Buttons must not be operated while in contact with water
World Time Zone Table
OFF SET
HOURS
STANDARD HOURS
0
+1
Paris/ Berlin/ Madrid
+2
+3
+4
+5
+6
+7
th
+8
.
+9
+10
+11
+12
•
For other County's time zone refer to World Time Zone map.
•
Can
Suitable for
Suitable for
Suitable
Suitable for
withstand
Swimming
Pool Size
for
high board
accidental
snorkelling
diving or sub-
splashing
or water
aqua diving
sports
No
No
No
No
No
Yes
No
No
No
No
Yes
Yes
Yes
No
No
Yes
Yes
Yes
Yes
No
Page 2
TIME ZONE
OFF SET
TIME ZONE
HOURS
STANDARD HOURS
London
0
London
-1
Cape Verde
Istanbul
-2
Mid-Atlantic
Moscow
-3
Greenland
Abu Dhabi
-4
Santiago
Islamabad
-5
USA (Eastern)
Dhaka
-6
USA (Central)
Bangkok
-7
USA (Mountain)
Beijing / HK
-8
USA (Pacific)
Tokyo Seoul
-9
Alaska
Sydney
-10
Hawaii
Guam
-11
Samoa
New Zealand
-12
Kwajalein
Page 5
Functions
-
Hours
-
Minutes
-
Seconds
-
Day of the Week
-
Date of the Month and Month
-
12-24 Hour Dial
-
World Time / Dual Time
-
Water Resistance – Check the back of the watch and refer to the Table.
Instructions for setting the Home time / Dual Time
Important: Before setting the World/Dual Time check if the World Time hour hand (red
hand) is synchronised to the full hour. If the hour hand is not synchronised to the full
hour then unscrew and pull the crown out to second position, turn the crown
clockwise until the hour hand is positioned exactly on the full hour, and then turn the
crown anti-clockwise until the minute hand is positioned exactly at 12 o'clock mark.
1)
Unscrew and pull the crown out to second position and turn the crown clockwise
to set the World/Dual time hour. Making sure the World/Dual time hour hand (red
hand) matches to the red hour indicator. For example, if the local time is 12
o'clock, duel time can be set for different country's local time i.e. Paris 1 o'clock.
Note: Only the cities with the full hour difference can be set, refer to the World Time Zone
table on Page 5.
2)
Once the correct duel time hour is set, turn the crown anti-clockwise to set the
correct home time, making sure the time is set to AM or PM.
3)
The 12/24 hour dial will indicate AM or PM.
4)
Rotate bottom left crown to select the desire city name of which the dual time is
set to.
5)
Rotate top left crown to adjust the position of the city name window to desire
place.
6)
Finally push and screw the crown back to normal position.
Page 3
Calibre 633
IN4102
Page 6
Advertisement
