Download Print this page

Zeon IN8702 CALIBRE 750 Operation Manual

Automatic watches

Advertisement

Quick Links

Calibre 750
Automatic Movement Operation Manual
Automatic watches can be used only by those who are reasonably active as the automatic
winding relies on a regular movement of the wrist. The watch must be given an initial manual
wind of 8 to 10 turns and provided that it is worn on the wrist for a minimum of 8 hours each
day it will continue to function indefinitely and may be taken off the wrist for a maximum period
of 30 hours. If this period is exceeded the movement will stop and another manual wind will be
necessary. It must be remembered that when worn in bed the movement of the wrist is
insufficient to operate the automatic winding.
Time Stand Accuracy
1)
21,600 beats per hours
2)
Accuracy between -30 to +30 seconds per day worn under normal conditions.
Butterfly Strap Adjusting Instruction
Firstly, open the butterfly buckle and then pull out the pin. Adjust the strap to the required
length, and then push back the pin into the correct hole. Finally, close the butterfly buckle until
it clicks into place.
Page 1
Instructions for Time Setting
1)
Pull the crown out to Second Position and turn the crown anti-clockwise until the
day of the week is correct. The day and date will now be corrected, now set the
time but make sure the time is set onto am or pm. Finally push the crown back to
the normal position.
2)
The 24 hour dial will indicate AM and PM.
Page 4
Water Resistance Table
Level of
Suitable for
Can
Suitable for
Suitable for
Water
Everyday
withstand
Swimming
Pool Size
Resistance
use
accidental
splashing
None
Yes
No
No
No
3 ATM
Yes
Yes
No
No
(30m/
100ft
5 ATM
Yes
Yes
Yes
Yes
(50m/
150ft)
10 ATM
Yes
Yes
Yes
Yes
(100m/
300 ft)
Water resistance is not permanent. In the course of time, the gaskets of the case and
crown may become worn and reduce the water resistance of your watch. We recommend
the periodic checking
Normal Crown – always make sure it is pushed fully into case
Screw down Crown – tighten screw down crown completely to screw lock position.
To maintain water –resistance crystal, crown and case must remain intact
Exposure to Salt Water
If your watch is designed for sports or working in the water and it becomes exposed to salt
water or significant amounts of perspiration, it should be rinsed in fresh water and dried
thoroughly with a soft dry cloth.
Important
Buttons must not be operated while in contact with water
Page 2
Calibre 750
IN8702
Page 5
Functions
-
Hours
Suitable
Suitable for
for
high board
-
Minutes
snorkelling
diving or sub-
-
Seconds (Split Seconds 0-30)
or water
aqua diving
sports
-
Date
-
AM/PM – Day & Night Dial
No
No
-
Water Resistance – Check the back of the watch and refer to the Table.
No
No
Important
No
No
Do not set the date between 06.00 PM and 06.00 AM, as this may cause
Yes
No
damage to the movement.
At the end of each month the date is required to be changed manually.
Instructions For Setting Date & Time
1)
To achieve and accurate date setting, by using a pointed device, press button A
until a date prior to the date you required is achieved i.e. if today is the 16
set it onto the 15
2)
Pull the crown out to First Position and turn the crown anti-clockwise until the
date is corrected. Now set the time but make sure the time is set onto am or pm.
3)
Finally push the crown back to the normal position.
4)
The AM/PM – Day/ Night dial will show Sun for AM and Moon for PM time.
th
.
Page 3
th
then

Advertisement

loading

This manual is also suitable for:

Calibre 750