Advertisement
Quick Links
273 Branchport Avenue
Long Branch, N.J. 07740
(800) 631-2148
www.wheelockinc.com
Use this product according to this instruction manual. Please keep this instruction manual for future reference.
MODEL NUMBERS:
SC-SPL-B
SC-SPL-R
GENERAL:
The Four Zone Splitter is designed to be used with Wheelock's Single Circuit SAFEPATH panel and it provides a means for expanding
the number of supervised audio output zones from one to four. The Four Zone Splitters are UL Listed under Standard 864, Control
Units for Fire Protective Signaling Systems. They are listed for indoor use only. Only 1 Four Zone Splitter can be connected to the
Single Circuit SAFEPATH panel. It is to be mounted inside the Single Circuit SAFEPATH panel enclosure onto the printed circuit board
(PCB) cover. The splitter works with all of the Wheelock amplifier modules. If the splitter is used with a power amplifier, the maximum
power per zone cannot exceed what is listed in Table 1.
SPECIFICATIONS:
Audio Output Voltage
Maximum Output Power Per Zone
MOUNTING INSTRUCTIONS:
Copyright 1997 Wheelock, Inc. All rights reserved.
Thank you for using our products.
INSTALLATION INSTRUCTIONS
FOUR ZONE SPLITTER
(FOR SINGLE CIRCUIT SAFEPATH PANELS)
Single Circuit Splitter - Black
Single Circuit Splitter - Red
Table 1.
25.0V
25.0W
Figure 1.
70.7V
70.0W
(4)
MOUNTING
HOLES
100.0V
100.0W
P83439 B
Sheet 1 of 4
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Wheelock SC-SPL-B
Summary of Contents for Wheelock SC-SPL-B
- Page 1 Single Circuit SAFEPATH panel. It is to be mounted inside the Single Circuit SAFEPATH panel enclosure onto the printed circuit board (PCB) cover. The splitter works with all of the Wheelock amplifier modules. If the splitter is used with a power amplifier, the maximum power per zone cannot exceed what is listed in Table 1.
- Page 2 Attach the 4 male PCB standoffs to the 4 mounting holes in the Single Circuit SAFEPATH PCB cover (see Figure 1) by pushing standoff into the hole until it locks into place as shown in Figure 2. Place the Four Zone Splitter PCB on to the threaded stud portion of the PCB standoffs so that the studs mate with the mounting holes on the PCB as shown in Figure 2.
- Page 3 OPERATING INSTRUCTIONS: When making a live emergency announcement from the Single Circuit SAFEPATH panel, use the Four Zone Splitter’s four zone ON/OFF switches to select the zones to which the audio will be broadcast or use the ALL CALL switch to select all of the zones. To select a zone, slide the zone ON/OFF switch up to the on position (Figure 4).
-
Page 4: Limited Warranty
WHEELOCK'S LIABILITY ON ANY CLAIM OF ANY KIND SHALL CEASE IMMEDIATELY UPON THE INSTALLATION IN THE PRODUCT OF ANY PART NOT FURNISHED BY WHEELOCK. IN NO EVENT SHALL WHEELOCK BE LIABLE FOR ANY CLAIM OF ANY KIND UNLESS IT IS PROVEN THAT OUR PRODUCT WAS A DIRECT CAUSE OF SUCH CLAIM. FURTHER, IN NO EVENT, INCLUDING IN THE CASE OF A CLAIM OF NEGLIGENCE, SHALL WHEELOCK BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Need help?
Do you have a question about the SC-SPL-B and is the answer not in the manual?
Questions and answers