Table of Contents
Advertisement
Quick Links
273 Branchport Avenue
Long Branch, NJ 07740
(732) 222-6880
Use this product according to this instruction manual. Please keep this instruction manual for future reference.
MODEL NUMBERS:
RMS-2B
RMS-2R
GENERAL:
The Remote Microphones are UL Listed under Standard 864, Control Units for Fire-Protective Signaling Systems. They are Listed
for indoor use only. The Remote Microphone is designed to be used with Wheelock's Single Zone SAFEPATH Panel model SC-
SAPE. It provides a means for making emergency voice announcements from an auxiliary location. Only 1 Remote Microphone can
be connected to the SAFEPATH Panel. The hand held push to talk microphone is supervised to ensure proper connection. It is not
replaceable. If it is detached from the unit, the unit must be returned for repair.
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT.
SPECIFICATIONS:
Power Input Voltage:
Audio Output Level:
Output Impedance:
Input Current:
WIRING DIAGRAM:
WIRING SPECIFICATIONS:
Cable Size:
Maximum Length:
1000 Feet
Maximum Capacitance: .05uF/Total Run (50pF/foot for 1000 FT.)
Copyright 1996, 1998 Wheelock, Inc. All rights reserved.
Thank you for using our products.
INSTALLATION INSTRUCTIONS
REMOTE MICROPHONE (SINGLE CIRCUIT)
Remote Microphone Single Circuit Black
Remote Microphone Single Circuit Red
20-31VDC
1.05V RMS
600 Ohms
50mA
14 - 22 AWG Shielded. The shield must be connected only at the SAFEPATH Panel.
Figure 1.
P83270 B
Sheet 1 of 5
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Wheelock RMS-2B
Summary of Contents for Wheelock RMS-2B
- Page 1 The Remote Microphones are UL Listed under Standard 864, Control Units for Fire-Protective Signaling Systems. They are Listed for indoor use only. The Remote Microphone is designed to be used with Wheelock’s Single Zone SAFEPATH Panel model SC- SAPE. It provides a means for making emergency voice announcements from an auxiliary location. Only 1 Remote Microphone can be connected to the SAFEPATH Panel.
- Page 2 MOUNTING INSTRUCTIONS: Figure 2. 1. Install a 4” gang backbox (either flush or surface) to the desired location. Be sure that the mounting box is level. 2. Attach the 6 wires as shown in the wiring diagram (Figure 1). Be sure to use the specified wire. 3.
- Page 3 DOCUMENTS DESCRIBING THE PRODUCT FOR USE IN PROMOTIONAL OR ADVERTISING CLAIMS, OR FOR ANY OTHER USE, INCLUDING DESCRIPTION OF THE PRODUCT'S APPLICATION, OPERATION, INSTALLATION AND TESTING IS USED AT THE SOLE RISK OF THE USER AND WHEELOCK WILL NOT HAVE ANY LIABILITY FOR SUCH USE.
-
Page 4: Limited Warranty
Limited Warranty Wheelock products must be used within their published specifications and must be PROPERLY specified, applied, installed, operated, maintained and operationally tested in accordance with these instructions at the time of installation and at least twice a year or more often and in accordance with local, state and federal codes, regulations and laws. - Page 5 (as determined by date code). Correction of defects by repair or replacement shall be at Wheelock's sole discretion and shall constitute fulfillment of all obligations under this warranty. THE FOREGOING LIMITED WARRANTY SHALL IMMEDIATELY TERMINATE IN THE EVENT ANY PART NOT FURNISHED BY WHEELOCK IS INSTALLED IN THE PRODUCT.
Need help?
Do you have a question about the RMS-2B and is the answer not in the manual?
Questions and answers