Monster AirTalk User Manual & Warranty Information page 13

Further Proceedings. Monster will determine whether a Product
Defect existed. Monster may, at its discretion, direct You to
obtain a repair estimate at a service center. If a repair estimate
is required, You will be instructed on how to properly submit the
estimate and the resulting invoice to Monster for payment.
Any fees for repairs may be negotiated by Monster.
Timing. If You bring a Formal Warranty Claim and fully comply
with all terms and conditions of this Limited Warranty, Monster
will use its best efforts to provide You with a remedy within
thirty (30) days after receipt of Your Formal Warranty Claim
(if You reside in the United States - forty-five (45) days if You
reside elsewhere), unless obstacles outside Monster's control
delay the process.
Ver.072109 – GLOBAL
©2003-2010 Monster Cable Products, Inc.
FCC ID: RJEADS200
This device complies with Part 15 of FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause
undesired operation. Changers or modification not expressly
approved by the party responsible for Compliance could void
the user's authority to operate the equipment. Connecting of
peripherals requires the use of grounded shielded signal cables.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is